sbalgach

Hi
I need to change the driver's front wheel bearing.
Can anyone offer any hints before I get started?
Thanks,
Steve

slideways...

hope you have access to a press.

__________________

Rice Police #1. dont argue with me just because you are a riceboy and/or have sand in your vagina. i am superior. and i am smarter than you. end of story.

sbalgach

Can the bearing be taken out without a press
I was thinkin just use a hammer!!!

slideways...

im not sure about that exact car, but unless you have an air hammer, big cutoff wheel, or a press, probably not. the issue comes in with the bearing race that sits on the spindle itself where the axle goes in. its very difficult to make a hammer work with nothing to really strike against. maybe someone can chime in whos done it on this very car?

__________________

Rice Police #1. dont argue with me just because you are a riceboy and/or have sand in your vagina. i am superior. and i am smarter than you. end of story.

Chiquae07

it needs to be pressed out and new pressed in. im pretty sure nismo will be able to chime in on this.

__________________
Suck up a kitten
Eat a butterfly
Replace with WRX

2001 Granite Sentra Se wit PP