drvitforever

I have a '94 pickup. Recently had brakes/rotors/pads replaced. Today, I wanted to lock wheel hubs to lubricate axle, but I can't turn one of the hubs to lock it. It turns very slightly, but sounds like it is hitting something. Could the brake job have affected the hub?

fourwd1

Yes, it's possible. The rotor is attached to the wheel hub, and you have to remove the locking hub to get the wheel hub/rotor off.

__________________
- - as seen in FOUR WHEELER magazine July 06 and OFF-ROAD magazine Feb 07 - -

84 4Runner - ARBed 5.29s F&R, 4.7 & 2.28 t-cases, Chevys, AP x-over, BudBuilt x-member, 2" drv trn lift, 36" TSLs, 30 spline Longs

80 something p/u - Buick 231 V6/TH-350 trans, Holley 4 bbl, Weiand intake, dual batts, dual tanks ...

89 4Runner - stock