I'd like to replace the two idler pulleys while doing my timing belt. They don't feel real bad but I didn't replace the idler on my Honda and it went out shortly after replacing the timing belt. Has anyone replaced just the bearing inside the pulley? I'm not able to cross the bearing #'s. The only thing that comes up in a search is this site:
http://www.datazap.net/sites/Austral..._Pump_rev2.pdf
ONe pulley has NTN bearing while the other has a nsk bearing. I'm going to the bearing house on Monday to see if they can cross it. The reasons for doing it this way is there are no replacement pulleys immediately available and when ordered, they are expensive. >$100 for both. I think I could replace the bearings for under $30, but I'll see. If I have any luck, I'll post the bearing numbers and It'll be a good thing to add to the FAQs.