matt96gt

Anyone know how to do the keyless entry for a 2000 LE? It has the 3 button remote. TIA.

matt96gt

OK, I found how to do it.

nicshow

I just received an extra remote fob with instructions on programming...but I'm not sure I understand. What am I programming? Am I programming a receiver in the car to recognize that particular remote?

lojeti

could you email me the instuction on how to do it. Email me a Lojet@tconl.com thanks

PSUlion01

i'm looking for the instructions as well...care to share?

nicshow

I can send you the instructions - if you'll send your email to me, I'll send it to you!

zmsaad

any body care to share this instruction. Thanks.email at zmsaad@yahoo.com. Thaks

sski

I am also in need of the instructions of you wouldn't mind sending them one more time.

sski@gte.net

Thanks in advance!


Steve

rlamb01

I'd like them too
rlamb01@yahoo.com

Breadman

Please send me a copy to.......Thanks.........Buddy.


bmgriffin@bellsouth.net

jianx23

Please email me a copy of the programming instruction.
2000 Camry LE remote
Greatly Appreciate!!!

jianx23@yahoo.com

James

mm1997

will they work for a 97 camry?

Breadman

Hello
97 model is not the same...but if you will look all over this camry site you will find something on the 97 i'm sure. Good luck.....Breadman

.............STILL LOOKING FOR HELP ON THE 01............................

mm1997

I found this for a 2001.........Still need help on my 97...........

Here it is?

2001 Camry Keyless Remote Programming
1. Start with
a. No key in ignition
b. Driver's door unlocked
c. All other doors locked
d. Driver's door open
2. Insert key into ignition and remove
3. Press lock, pause, unlock (2 second total cycle) 5 times
4. Close, then open driver's door
5. Repeat lock, pause, unlock cycle 5 additional times
6. Insert key into ignition and turn from lock to "on" two
times (pause in
each location 1 second). (note: "ON" not accessory position)
7. Remove key from ignition
Locks should cycle twice. If not, start over.
8. Press lock and unlock buttons on transmitter
simultaneously for 1-2
seconds then release
9. Press lock and unlock buttons on transmitter again
simultaneously
for 1-2 seconds then release
10.Press lock alone for 1 second, then release
Locks should cycle once
11. Close Driver's door to exit program mode.
If you want to program more than one remote, repeat steps 8 - 10 with the second remote before finishing with #11.

niwre

i plan to purchase a keyless entry for my 2000 camry. can somebody help me to give me points to consider when purchasing a keyless entry device? What should i look after?

And can you also send me a copy of the instructions just in case? erwindxb@yahoo.com

Thank you very much