gmctruck06

I just recently put in a python remote start system on my 97 blazer. The problem I have is that if the system starts the vehicle then it sets all kinds of codes for the tranny. If I start it, then the codes don't set. What circuit do I need to power up in order for these codes to not set? Any electrical diagrams of the tranny circuits would be greatly helpful.

goser

Double check your wiring at www.bulldogsecurity.com. Did you hook up both ignition wires? Neutral safety switch?

gmctruck06

Thanks goser. The python book says nothing about needing to power the tranny at start up. I'll give it a shot and post results.