galleym

I have a '96 2.2L Sunfire that is just about on it's last legs. There is a wicked sounding vibration or rubbing coming from the front drivers side wheel. It is bad enough when going straight but it gets even worse when turning. I have replaced the bearing in this wheel twice and it has new brakes. Could this be the bearing again? Any help would be appreciated.

hotbug1776

what about the axle, did you ever replace that? they wear out, I'm on my second set for the 95.

__________________

godenm

ive put 7 wheel bearing assemblys(3onleft/4onright) on my 98 z24,and they are always installed correctly,they just start to hum/vibrate. i think my problem is that i hav always had oversized aftermarket wheels,and cornering 25mph curves at 95mph dont help either haha.but i also agree with hotbug,maybe check yur axles/cv joints

__________________

Classicrocjunkie

I third that motion...

__________________
Please don't PM me with your J-body Issues. Post appropriately in the forums,
and I will toss my opinion in your thread if I have anything to help. - Thanks!

2004 Pontiac Sunfire Coupe SE Getrag 5 speed
2009 Subaru Impreza WRX 5-door



www.Rdfabs.com

big dude1

i fourth it... lol cv axle went out on my friends prelude and it ripped the hell outta the underside of his car... might wanna get it checked ASAP...

__________________
i love my new sound system... Alpine type R 12" sub, Alpine deck, and MTX amp

2001 Z24 cavi, and it owns