I had a Sparco aluminum pedal set that I pulled from my Audi and had been meaning to install them in the Xterra. Well, they were too big to fit in the X so I put it off...until today. Finally, I cut them so the look more or less like the factory covers, sanded, and installed them. I was surprised at how easy it was to drill through the Xterra pedals. It only took a few seconds. I remember on the Audi that I had quite a bit of trouble drilling through. Thanks Nissan for making it easy (I think!). Anyway, here's a picture of the end product. It should be nice to not have to worry about getting my shoes stuck on the sides of the pads and pulling them off anymore. Notice these pedals have a rough surface for traction, in case anyone is concerned about water and mud.

Now my Xterra has some Italian blood! :D

Here ya go!

Don't go getting all Uncle Ben's on us now!

Hey, there's no Uncle Bens in those! These are real aluminum with real bolts and Italian made. I don't do the fake carbon fiber stick on crap! :bathroom:

Sheesh, as IF! :D

Oops! Italiano.... my bad... delete the Uncle Bens comment and insert Chef Boyardee :sun:

I prefer Ronzoni! :jump:

You're just jealous!