Automotive Forums .com - the leading automotive community online! Visit IgorSushko.com and see what it's like racing in Japan
-
Google  
Web AF
See Latest Posts
Access AF from your phone - point your mobile browser to http://m.automotiveforums.com
Go Back   Automotive Forums .com Car Chat > Jeep > Wrangler
Reply Show Printable Version Show Printable Version | Email this Page Email this Page | Subscription Subscribe to this Thread
 
Thread Tools
Old 11-10-2004, 12:32 PM   #1
Jontp
AF Newbie
 
Join Date: Dec 2003
Location: Louisa, Virginia
Posts: 1
Jontp Normal reputation
Red face 2003 wrangler DTC P1494

I have a 2003 Jeep Wrangler. The check engine light came on. The DTC ( diagnostic trouble code ) that comes up in the oddometer is P1494. Looking online i found that this is referring to a leak detector pump. Anyone have a clue what this is, where it is, and how to fix it ? Can this damage the engine if I keep driving it ?
Jontp is offline   Reply With Quote
Old 11-10-2004, 10:33 PM   #2
hundahunta
AF Enthusiast
 
Join Date: Aug 2004
Location: Wahiawa, Hawaii
Posts: 520
hundahunta Normal reputation
Re: 2003 wrangler DTC P1494

leak detection pump or mechanical fault..

REMOVAL
The Leak Detection Pump (LDP), LDP Filter, and EVAP canister are attached to a common support bracket. This support assembly is located to the rear of the right / rear tire under the plastic wheelhouse liner (EVAP CANISTER / LDP LOCATION). The LDP filter is also located near the EVAP canister (DISCONNECTING ORVR VAPOR LINES). The LDP and LDP filter are replaced (serviced) as one unit.

Remove right/rear tire/wheel.
Remove wheelhouse liner at right/rear wheel.
Remove vertical support bracket (EVAP CANISTER / LDP LOCATION) to gain access to 2 ORVR vapor lines.
Two vapor lines connect the fuel tank to the EVAP canister and Leak Detection Pump (LDP). This connection is made near the right/rear corner of the fuel tank. Carefully disconnect these 2 vapor lines (DISCONNECTING ORVR VAPOR LINES) near top of flow management valve. Be very careful not to bend or kink the vapor lines. If lines leak, a Diagnostic Trouble Code (DTC) will be set.
Remove common support bracket assembly (COMMON SUPPORT BRACKET ASSEMBLY) containing LDP pump, LDP filter and EVAP canister from vehicle. While lowering this assembly, disconnect LDP electrical connector (COMMON SUPPORT BRACKET ASSEMBLY) at LDP pump. Do not allow the assembly to hang from the wire harness.
Carefully separate hose at bottom of LDP filter.
Carefully remove vapor/vacuum lines at LDP.
If necessary, remove LDP filter mounting bolt and remove filter.
Remove EVAP canister from common support bracket by removing 4 nuts (COMMON SUPPORT BRACKET ASSEMBLY).
Remove 3 LDP mounting bolts (LDP MOUNTING BOLTS) and remove LDP from support bracket.



the vehicle is still under warranty, it will not damage anything it is for emissions...
hundahunta is offline   Reply With Quote
 
 
 
 
Reply

POST REPLY TO THIS THREAD


Bookmarks
Go Back   Automotive Forums .com Car Chat > Jeep > Wrangler

« Previous Thread | Next Thread »
Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 12:48 AM.

Google  
Web AF
Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
no new posts