Automotive Forums .com - the leading automotive community online! Visit IgorSushko.com and see what it's like racing in Japan
-
Google  
Web AF
See Latest Posts
Access AF from your phone - point your mobile browser to http://m.automotiveforums.com
Go Back   Automotive Forums .com Car Chat > Toyota > Corolla/Matrix/Voltz
Reply Show Printable Version Show Printable Version | Email this Page Email this Page | Subscription Subscribe to this Thread
 
Thread Tools
Old 06-25-2004, 07:59 PM   #1
steveandles
AF Newbie
 
Join Date: Jun 2004
Location: kaneohe, Hawaii
Posts: 1
steveandles Normal reputation
valve tapping when engine is cold

I am hearing a tapping sound in the engine(valves tapping?) when the engine is cold. After running for 1/2 hour or so, the tapping stops.
Well, it doesn't stop completely but it's not as loud.
A mechanic told me to use engine flush the next time I change the oil.
Will this solve the problem?

Also, when the ac compressor cycles on, I hear a "rattling" sound.
What could be causing this?

Steve M.
steveandles is offline   Reply With Quote
Old 07-05-2004, 07:00 AM   #2
hooba
AF Newbie
 
Join Date: Jul 2004
Location: riverview, Florida
Posts: 14
hooba Normal reputation
Re: valve tapping when engine is cold

I just went throught the ratteling in the compressor, it could be low on a/c oil. If yours is R134, try adding 2ounces of oil. you can buy it at any parts store. If that doesent stop the rattle, the compressor may be shot. I was filling mine up about every 4-6 weeks because it had a very slow leak, probably in the evaporater. The commpressor final froze up on me. I replaced it with a used one from the junk yard and so far its been running fine
hooba is offline   Reply With Quote
Old 07-06-2004, 09:08 PM   #3
ishop4less
AF Enthusiast
 
Join Date: Jul 2004
Location: ventura, California
Posts: 112
ishop4less Normal reputation
Re: valve tapping when engine is cold

valves tapping means need to have valve adjustment, this day toyota using the valve shim and is not too expensive to repair if you know how. Engine flush will not do the job, it is common problems for toyota if you have high mileage and lack of change oil.
ishop4less is offline   Reply With Quote
Old 07-06-2004, 10:04 PM   #4
sonnald
AF Newbie
 
Join Date: Mar 2004
Location: Seattle, Washington
Posts: 24
sonnald Normal reputation
Re: valve tapping when engine is cold

Not all rattling comes the valve. My 92 Corolla had a rattling that sounded identical to valves when the engine was cold, it turned out to be the bearings in the belt idler. If applicable , carefully squirt some WD40 when you hear the noise around this area to locate noise source if applicable.
sonnald is offline   Reply With Quote
Old 07-07-2004, 10:50 AM   #5
WissNX01
Banned
 
WissNX01's Avatar
 
Join Date: Jul 2004
Location: Riverside, California
Posts: 330
WissNX01 Has more negative feedback than positive
Send a message via Yahoo to WissNX01
Valves can make noise when you start up, because oil has to work its way up the oil galleries and whatnot to get to the valves. It takes longer depending on what kind of oil filter you use. The best oil filters are factory one and the Fram X2. they retain the oil when the car shuts off. other oil filters empty when the car is shut off. Meaning, they have to fill up before the oil gets anywhere above the block. YOu can spend 10 bucks either way and get a good oil filter. Also, those two types tend to last longer, upwards of 5- 7500 miles. You could always just change the oil and leave the filter for two changes. Something to thnk about.

Also on oil, toyota has a problem with oil sludging. If you notice your not changine out as much oil as your are putting in, take off your valve cover. Sometimes its all sludged under it. Pennzoil is also recycled oil and will definatly sludge, so dont buy that crap.

True your valves could probably use a shim or an adjustment.
WissNX01 is offline   Reply With Quote
 
 
 
 
Reply

POST REPLY TO THIS THREAD


Bookmarks
Go Back   Automotive Forums .com Car Chat > Toyota > Corolla/Matrix/Voltz

« Previous Thread | Next Thread »
Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 08:47 AM.

Google  
Web AF
Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
no new posts