Low beam headlamps do not work....

[rockdude]

well ladies and gentlemen i am a gm tech and i say the problem is a corroded wiring at the splice for the low beam circuit feed you must open hood removed plastic shield around front hood latch assembly remove the right front headlight assembly removed the conduit from the harness that runs through there you will see it it is only one harness ,remove the black covering (tape) and find the section of the taped harness where multiple wires are (soldered together) cut section out if wire is green in color and strip and reconnect wires with new heat shrink butt-connector. wala concern corrected .. just a note ..hope this helps..

[z-24]

well I am not a GM technician and I say that I just had the same problem, went to autozone and bought a new headlight switch for 46 dollars took the steering column apart switched the switches and it was as good as new. I did also check all of my wires from my headlights and there was in fact no corrosion of any type. but my problem now is that I am afraid to put the airbag back into the steering wheel because I am afraid that it may deploy, any step by step descriptions would be greatly appreciated. Thanks

[Shawnettinger]

on my cavalier as soon as i pressed the trunk release my daylights nightlights, doom light dash lights stoped working what might be the problem what is wrong with these cavaliers

[yhandor]

hey what are the steps to removing the switch.......mines done and needs replacing.......how do you get it out from start to finish? thanks

[Shawnettinger]

What happened with my 1990 chevrolet cavalier z24 was as soon as i popped my trunk realease all my light when out and it turn out that the guy i bought it from did a shity wiring job so i look threw the wiring harness and found a rubber caseing with a mini fuze in it i dont know how this guy wiried this stupid thing but it something you should look out for if you bought your car seconde hand for stupid people who think they can rewire cars!!!!!

[popecg]

I have replaced the headlight plugs, the headlight switch assembly and still do not have low beams. Everything else works. Guess I will check the wiring harness next.

[popecg]

Just remove the bottom 3 screws found underneath the steering column and both parts pop right off. The switch assembly is held down by two bolts (about 3/8ths. head) ... and the two plugs-ins pop right out. Good luck