Starting the LS1 Swap

[eric1h]

Originally Posted by NZGTRA17

Eric, how is the new short block install coming along? What heads did you choose and what sort of specs are you running on the new cam? When are you dynoing?

Kel.

Funny you should ask, i was down there today finishing up the accusump install today. The new motor is in everything is hooked up, just need to tighten the oil lines and mount the accusump, dump some oil in it, and pray for the best!!!

The heads are stock 241's with upgraded PRC dual springs/retainers and the cam specs are

226/230 .598”/.600” 111LSA +4 advance (with 1.7 ratio rockers)
Comp EPS/EPS lobes 54-000-11 3 bolt cam core


I hope to dyno late next week or early the following week.


Thanks for checking in, its VERY close!


I'll post some pics later

[NZGTRA17]

Originally Posted by eric1h

Funny you should ask, i was down there today finishing up the accusump install today. The new motor is in everything is hooked up, just need to tighten the oil lines and mount the accusump, dump some oil in it, and pray for the best!!!

The heads are stock 241's with upgraded PRC dual springs/retainers and the cam specs are

226/230 .598”/.600” 111LSA +4 advance (with 1.7 ratio rockers)
Comp EPS/EPS lobes 54-000-11 3 bolt cam core


I hope to dyno late next week or early the following week.


Thanks for checking in, its VERY close!


I'll post some pics later

Eric, great to hear things are progressing well. Look forward to hearing how the dyno session goes.

Kel.