Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
| Latest | 0 Rplys |
|
Show Printable Version | Email this Page | Subscribe to this Thread |
|
Thread Tools |
02-16-2009, 07:43 PM | #1 | |
AF Newbie
Join Date: Feb 2009
Location: Janesville, Wisconsin
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
|
96 geo tracker knocks 1-3 gears and quiet in 4th and 5th
I have a '96 Geo Tracker and it runs great BUT when starting out and shifting to second then third it knocks like a rod went out in the motor, but when shifted to fourth or fifth it is fine. Does anyone have any insight on what the *#^@ is going on? The clutch does not slip either and the transmission was replaced last year. I know it is not the motor but have not looked into anything as of yet. Just thought I would get some ideas before I start snooping around and probably break stuff!!
|
|
02-21-2009, 10:24 PM | #2 | |
AF Newbie
Join Date: Jul 2008
Location: Milton, Georgia
Posts: 10
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: 96 geo tracker knocks 1-3 gears and quiet in 4th and 5th
Might check valve clearances etc - recommended every 15000 miles. Also if it is a manual, check clutch cable - it can cause some funky stuff - and they last about 2 years if you drive the vehicle. Some times a rod will be noisy at rpm and load rpm combinations. But it sounds like something loose in the trans - maybe a cracked ring gear only used in those ranges.
|
|
|
POST REPLY TO THIS THREAD |
|
|