Automotive Forums .com - the leading automotive community online! Automotive Forums .com - the leading automotive community online!
Automotive Forums .com - the leading automotive community online! 
-
Latest | 0 Rplys
Go Back   Automotive Forums .com Car Chat > Honda > Odyssey
Reply Show Printable Version Show Printable Version | Email this Page Email this Page | Subscription Subscribe to this Thread
 
Thread Tools Search this Thread
Old 01-07-2019, 08:24 PM   #1
RyanSwagMechanic
AF Newbie
 
Join Date: Jan 2019
Location: Newark, Delaware
Posts: 16
Thanks: 0
Thanked 2 Times in 2 Posts
2005-2010 Honda Odyssey Sliding Door Slider Replacement

2005-2010 Honda Odyssey Sliding Door Slider Replacement

Tools:
Long Phillips
Flathead Screwdriver
10, 12mm sockets
Needle Nose Pliers
Hammer
Floor Jack
Scan Tool

Problem:
Sliding door not operating correctly.

Diagnosis:
May experience electronic door issues as popping open and beeping, door will not open and close smoothly or get stuck and not move at all. Causes can be wear and tear, using the bottom door support as a step, damaged door track. If the problem is not resolved with electronic doors the slider may cause premature motor assembly failure.

Repair:
Carefully get the door to the middle position. If the door is shut use a scan tool to release the door then release the motor clutch to move the door without causing further damage. Open the trunk and take your flat head screwdriver and pop the two cover caps off of the taillight. Remove the taillight assembly. That then exposes a 10mm bolt. Remove that. By the seat belt of the middle row will be a screw. Using your long reach screw driver remove the screw that is by the track. Going to the back of the car place your hand on the panel above the track and carefully slide it toward the front of the car. That then exposes the whole track. Take your floor jack and prop the back bottom corner of the door. Then take your 12mm and remove the two bolts that hold the slider to the door. Since you used a floor jack roll the door forward to allow yourself more room to replace the slider. You then want to position the slider so you move the bottom straight up until it removes off of the tracks. If you have a scan tool and haven't already released the clutch of the motor do so now. Take your needle nose pliers and remove the cables from the slider. (Similar to a bicycle cable) Most replacement sliders only come with the sliders and not the back piece of the hinge to the slider. If this is the case take your flat head and remove the c ring. Taking your hammer tap the pin out of the hinge and assemble your new slider.

Last edited by RyanSwagMechanic; 01-10-2019 at 01:21 PM.
RyanSwagMechanic is offline   Reply With Quote
 
Reply

POST REPLY TO THIS THREAD


Bookmarks
Go Back   Automotive Forums .com Car Chat > Honda > Odyssey

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 06:07 AM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts