Automotive Forums .com - the leading automotive community online! Automotive Forums .com - the leading automotive community online!
Automotive Forums .com - the leading automotive community online! 
-
Latest | 0 Rplys
Go Back   Automotive Forums .com Car Chat > Jeep > General Discussion
Reply Show Printable Version Show Printable Version | Email this Page Email this Page | Subscription Subscribe to this Thread
 
Thread Tools
Old 04-03-2014, 02:00 PM   #1
airboss20
AF Newbie
 
Join Date: Mar 2006
Location: Horseheads, New York
Posts: 49
Thanks: 0
Thanked 0 Times in 0 Posts
Carter W-O rebuild on L134 CJ-2A

I just finished rebuilding the Carter W-O carb on my 48 Willy's CJ-2A with the 2.2L L134 Go Devil. I also replaced the spark plugs. Now it will not idle or run at all unless fully choked. I have played with the idle and other adjustments on the carb and tried adjusting the timing, but I'm just guessing here. I did have to adjust the float to clear 3/8" due to the new needle valve but all else went together well. The exhaust is making popping noise as well. Smells rich.
airboss20 is offline   Reply With Quote
Old 04-12-2014, 02:18 AM   #2
abraham98
AF Newbie
 
Join Date: Apr 2014
Location: dhaka
Posts: 8
Thanks: 0
Thanked 0 Times in 0 Posts
Re: Carter W-O rebuild on L134 CJ-2A

wish you good luck for future
abraham98 is offline   Reply With Quote
Old 05-25-2022, 07:00 AM   #3
Blue Bowtie
Registered Offender
 
Blue Bowtie's Avatar
 
Join Date: Mar 2006
Location: Rural
Posts: 6,517
Thanks: 6
Thanked 341 Times in 336 Posts
Re: Carter W-O rebuild on L134 CJ-2A

I'll be doing the same thing on this barn-stored version, also a '48, very soon. It runs on starter fluid manually fed through the air horn but the inlet needle won't accept fuel. Hopefully I have better luck.

__________________
Permanent seat assignment on the Group W bench...
Automotive Forums Survival Guide
Blue Bowtie is offline   Reply With Quote
Old 06-05-2022, 11:46 AM   #4
Blue Bowtie
Registered Offender
 
Blue Bowtie's Avatar
 
Join Date: Mar 2006
Location: Rural
Posts: 6,517
Thanks: 6
Thanked 341 Times in 336 Posts
Re: Carter W-O rebuild on L134 CJ-2A

My rebuild was very straightforward, with the only struggle getting the accelerator pump check balls to stay in place for assembly without packing them in grease. Got it, though. It's a wee bit lean at tip in, but runs fine.
__________________
Permanent seat assignment on the Group W bench...
Automotive Forums Survival Guide
Blue Bowtie is offline   Reply With Quote
 
Reply

POST REPLY TO THIS THREAD

Go Back   Automotive Forums .com Car Chat > Jeep > General Discussion

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 05:17 PM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts