Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
| Latest | 0 Rplys |
|
Show Printable Version | Email this Page | Subscribe to this Thread |
|
Thread Tools |
07-18-2011, 09:22 PM | #1 | |
AF Newbie
Join Date: Apr 2009
Location: Yakima, Washington
Posts: 5
Thanks: 1
Thanked 0 Times in 0 Posts
|
Yet anothe A/C issue
Hello, all.
I have an '02 Town and Country, 3.3L, with manual A/C that is not working. It is blowing warm air. I have checked the compressor; it cycles on and off. I have checked the R134A charge, and it is adequate. I have checked and rechecked the controls, to see if there is a blend issue. None that I can find. I have replaced the blower motor resistor three different times; I got an el cheapo the first two, and a good one on the third. fan is working like it should. Does this thing have a module in the control panel that could be bad? I cannot locate a test procedure. I'm stumped, and I have a very upset wife. Any help would be appreciated. |
|
07-19-2011, 07:39 AM | #2 | |
AF Regular
Join Date: Jan 2005
Location: Pittsburgh, Pennsylvania
Posts: 331
Thanks: 25
Thanked 21 Times in 21 Posts
|
Re: Yet anothe A/C issue
RIP posted a link in this thread that shows how to run a calibration procedure:
http://www.automotiveforums.com/vbul...ht=calibration Are any of the A/C lines going into the firewall cold? If so, then it's probably a calibration problem. If not, it's an A/C issue. |
|
The Following User Says Thank You to Alphabravo For This Useful Post: |
Mike G. (07-19-2011)
|
|
POST REPLY TO THIS THREAD |
|
|