Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
| Latest | 0 Rplys |
|
Show Printable Version | Email this Page | Subscribe to this Thread |
|
Thread Tools |
03-21-2013, 08:49 AM | #1 | |
AF Enthusiast
Join Date: Dec 2004
Location: Shellsburg, Iowa
Posts: 3,218
Thanks: 8
Thanked 1 Time in 1 Post
|
Power steering pump replacement?
I'm trying to replace the power steering pump in a '91. I got the pump and extension housing off the engine, but I don't see how the pump can separate from the housing to pull the coupler off the power steering shaft. I assume there is a special tool, but I can't even find a reference to one online. Can anyone help?
Thanks, Jason
__________________
'04 Cavalier coupe M/T 2.2 Ecotec Supercharged 14 PSI boost, charge air cooler, 42# injectors Tuned with HP Tuners Poly engine/trans/control arm bushings Self built and self programmed progressive methanol injection system |
|
03-21-2013, 11:11 AM | #2 | |
AF Enthusiast
Join Date: Aug 2011
Location: Beachside
Posts: 2,000
Thanks: 4
Thanked 303 Times in 301 Posts
|
Re: Power steering pump replacement?
Alldata lists two special tools for this repair...
JD119 and 18G-1445. I don't know if you can use one without the other, but I think the one you are looking for is the JD119. Good luck! |
|
The Following User Says Thank You to gmtech1 For This Useful Post: |
J-Ri (03-21-2013)
|
03-21-2013, 01:50 PM | #3 | |
AF Enthusiast
Thread starter
Join Date: Dec 2004
Location: Shellsburg, Iowa
Posts: 3,218
Thanks: 8
Thanked 1 Time in 1 Post
|
Re: Power steering pump replacement?
Thanks for looking that up. Can't seem to find either of those tools though.
I managed to get it off, only took 5 hours... just glad nobody was watching me LOL. Used a 2-jaw puller (had to cut off the short side of the arms, trim part of the long end off and combine parts from 2 puller sets). Modified a bolt to center in the hole in the shaft (the bolt on the puller will press into the hole otherwise and adapters on end of it don't let the thing come off), drilled an indentation in the head for the puller screw to center on. Wasn't pretty or easy, but it's apart... I'm taking a break from modifying my P/S pulley installer to go back together. If anyone else runs into this, ignore the 1.5 hours they give unless you have the special tools. At least 3 hours plus something for the tools you'll have to modify.
__________________
'04 Cavalier coupe M/T 2.2 Ecotec Supercharged 14 PSI boost, charge air cooler, 42# injectors Tuned with HP Tuners Poly engine/trans/control arm bushings Self built and self programmed progressive methanol injection system |
|
|
POST REPLY TO THIS THREAD |
|
|