Automotive Forums .com - the leading automotive community online! Automotive Forums .com - the leading automotive community online!
Automotive Forums .com - the leading automotive community online! 
-
Latest | 0 Rplys
Go Back   Automotive Forums .com Car Chat > Nissan > 240Z | 260Z| 280Z | 300ZX (Past Z Cars)
240Z | 260Z| 280Z | 300ZX (Past Z Cars) The original Z cars - ones that started it all.
Reply Show Printable Version Show Printable Version | Email this Page Email this Page | Subscription Subscribe to this Thread
 
Thread Tools Search this Thread
Old 12-07-2012, 05:51 PM   #1
HateNissan
AF Newbie
 
Join Date: Dec 2012
Location: Winsted, Connecticut
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
Good computer does not bulb test, spark problems

We have a 1984 Nissan 300 ZX with no spark. New ECU. Coil, Distributor and all associated hardware is new or good.
Turn on the ignition key and the ECU does not bulb test or give error codes unless you momentarily ground terminal 6 whereupon it will give codes (only AC errors) and then won't turn off when the switch is turned off. Dealer won't work on it and Nissan USA knows nothing and doesn't want to help.
Below is attempt to fix summary:
I will first list parts replaced:
ECM 3 times
LED assembly in the distributor
power transistor
cylinder head temp sender (from a trouble code)
coil
EFI relay
timing belt

Things done and checked:
Checked output from dist to ECM, got the 360 signal and 1 other signal (assuming #1 cyl) with a good oscilloscope.
power to + side of coil
power to ECM
All grounds I could find with help from Alldata and an 84 300zx troubleshooting disc.
Condenser between coil from and ground @ dist base

Engine cranks normally, no spark from coil secondary. Checked and found no pulse on - side of coil.
Ignition on, ECM would not boot even with power on the proper pin at the ECM, unless a momentary ground of the #6 red wire at the ECM, from the EFI relay. Once powered up, turned screw to get codes, got 2 relating to the A/C. However, when ignition switch off, the ECM stays powered up (checked for 15 minutes) until ECM physically unhooked from harnesses. I have contacted the local Nissan dealer, and they disavow any knowledge and desire to tackle this, so in my shop it still sits.
If anyone there has any ideas, information or experience with this type problem, I sure would be grateful for help."
HateNissan is offline   Reply With Quote
 
Reply

POST REPLY TO THIS THREAD


Bookmarks

Tags
300zx, ignition, problems
Go Back   Automotive Forums .com Car Chat > Nissan > 240Z | 260Z| 280Z | 300ZX (Past Z Cars)

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 03:32 AM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts