Automotive Forums .com - the leading automotive community online! Automotive Forums .com - the leading automotive community online!
Automotive Forums .com - the leading automotive community online! 
-
Latest | 0 Rplys
Go Back   Automotive Forums .com Car Chat > Ford > Escort
Reply Show Printable Version Show Printable Version | Email this Page Email this Page | Subscription Subscribe to this Thread
 
Thread Tools
Old 03-16-2016, 06:48 PM   #1
Donnyten
AF Newbie
 
Join Date: Mar 2016
Location: Durham
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
PCV plastic tube for 92 escort lx wagon 1.9L

Was servicing my vehicle today and this tube snapped in half. Called ford, dont have it since its an 'obsolete' legacy part.

Tried 1aauto, rock auto, both dont have it.

Am I out of luck? is there an alternative? can I just use a rubber hose instead to connect the pcv valve to the other end part?
Donnyten is offline   Reply With Quote
Old 03-26-2016, 07:19 PM   #2
denisond3
AF Enthusiast
 
Join Date: Mar 2007
Location: VA in summer, TX in winter, Virginia
Posts: 1,323
Thanks: 2
Thanked 13 Times in 13 Posts
Re: PCV plastic tube for 92 escort lx wagon 1.9L

If you are talking about the plastic tube that connects the PCV valve on the front corner of the engine, with the fittings on the intake manifold - any way you can repair it would be fine. Most of the time it handles vapors at very little pressure. A rubber fuel line slid over it would work.
The usual failure point is at the rubber elbow where the end of the plastic tube connects onto the intake manifold. Ford didnt sell that by itself either - but years ago they would sell you the entire plastic tube and the rubber elbow as an assembly - for $23. The parts guys did this with a straight face too.
Anyway, when that rubber elbow gets dried out and sucked in, it will amount to a big leak to the intake, and cause stumbling and stalling. I have seen guys use a rubber tube (3/*" diameter I think) to replace it. I found some brass 90 elbows with barbs for 3/8" hose, and installed one of those, with 3/8" fuel line to mate it to the tube on the intake manifold and the plastic tube from the Positive Crankcase Ventilation valve.

if your Escort one of those which does not have an EGR valve? It mounts to the back side of the intake manifold just next to the throttle valve, and has a steel tube running down to bung into the exhaust pipe. The 92 and 93 Escorts didnt have EGR systems for the Federal versions, though they did have EGR systems in California. Its strange that the 91LX Escorts did have EGR systems, as did the 94LX and later ones - but the 92 and 93 got away without them.
I own 4 2nd gen Escorts, and have 3 others in my family. They four I have are all daily drivers for the wife and I; two of them at each of the two places we live in seasonally.
Good Luck with your car.
denisond3 is offline   Reply With Quote
 
Reply

POST REPLY TO THIS THREAD

Go Back   Automotive Forums .com Car Chat > Ford > Escort

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 03:57 PM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts