Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
| Latest | 0 Rplys |
|
Show Printable Version | Email this Page | Subscribe to this Thread |
|
Thread Tools |
06-22-2004, 03:08 PM | #1 | |
AF Newbie
Join Date: Jun 2004
Location: Oaklyn, New Jersey
Posts: 4
Thanks: 0
Thanked 0 Times in 0 Posts
|
302 valve adjustment
Getting ready to drop the 302 back into the 69. Had the heads reworked with hardened seats, polished and ported and new retainer studs. I'm not sure how to go about adjusting the valves from scratch. Any advise is welcomed. Thanks.
|
|
06-22-2004, 05:46 PM | #2 | |
AF Fanatic
|
Re: 302 valve adjustment
start with getting #1 top dead center.... while spinning the pushrods tightin the rocker slowy until you feel tension, then tightin 3/4 a turn.... do that with every cylinder.. make sure there all top dead center b4 you tightin them and the lifters are all the way down and even
|
|
06-22-2004, 08:32 PM | #3 | |
AF Regular
|
You didnt mention if you have stud mount or pedestal rockers as the adjustment methods are different.
For stud mounts you adjust them essentially how ridge_runner said, just make sure the valve you are adjusting is on the base circle of the cam and tighten down 1/2 to 3/4 turn. Pedestals are a little more complicated since they need shims. Crane Cams has a good adjustment how-to on their site.
__________________
1968 Mustang notchback Roller 302, Edelbrocks, Hookers, side-exits, RRs, Crane 2031, Duraspark, forged slugs, X-Celerator, 650DP, Fidanza FW, RAM clutch, Toploader, Comp Plus, McLeod bell, 15x7s, 1 1/8 swaybar. 1972 Ford Pinto SVO 2.3 turbo, MegaSquirt, T5, 8", etc. '95 Honda XR600-10.5:1, 628cc, ported head, & more. |
|
|
POST REPLY TO THIS THREAD |
|
|