Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
| Latest | 0 Rplys |
|
Show Printable Version | Email this Page | Subscribe to this Thread |
|
Thread Tools |
12-07-2011, 12:21 PM | #1 | |
AF Newbie
Join Date: Dec 2011
Location: quad city, Illinois
Posts: 3
Thanks: 0
Thanked 0 Times in 0 Posts
|
1998 Ram no start code P0340
i have a 1998 ram 1500 4x4 318, it will turn over but not fire.
i have replaced the following: cap, rotor, camshaft sensor / pick-up coil was told they were same thing??, crankshaft sensor finally got my hands on a code reader. NO LINK. towed it to a shop specializing in electrical. told computer was bad, had new one install. ran great drove it home, to work next day, stopped for fuel. now it wont start, same type problem. turns over no fire. this time coad reader says P0340, any suggestions??? |
|
12-08-2011, 01:32 PM | #2 | |
AF Newbie
Thread starter
Join Date: Dec 2011
Location: quad city, Illinois
Posts: 3
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: 1998 Ram no start code P0340
now it started right up, didn't do anything but turn the key.
so i drove it home, cleared code, double checked connection for camshaft sensor. so far so good, it still starting every time. could i have a weak battery? |
|
12-08-2011, 05:47 PM | #3 | |
AF - Advisor
Join Date: Mar 2004
Location: Nashville, Tennessee
Posts: 2,919
Thanks: 112
Thanked 41 Times in 39 Posts
|
Re: 1998 Ram no start code P0340
P0340 No Cam Signal At PCM.
No fuel sync. If there's enough battery energy to crank the engine over a pretty good clip, there should be enough energy to operate the electronics imo.
__________________
1992 Bravada, 201K, stock 1997 Bravada, 101K, stock...was "called away" "Cornbread Red", 2001 Dodge 2500,4X4,HO Cummins Diesel,QC,SWB,6spd.,Banks boost&pyro,US Gage fuel press.,Edge Drag Comp,4"exh.,cowl hood, bhaf, black Holley pump, 140gph...13psi WOT, Vulcan Big Line, kevlar/ceramic single disc clutch, cheapo fuel cooler, 8x.010" vco injector nozzles, Cat turbo 62-65-.70A/R, 497hp 1089 tq 8/25/14 Time to turn so's you don't burn. |
|
12-08-2011, 09:48 PM | #4 | |
AF Newbie
Thread starter
Join Date: Dec 2011
Location: quad city, Illinois
Posts: 3
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: 1998 Ram no start code P0340
it does turn over at a good clip, volt meter reading 12.6 and if it starts reads 14.
acted up again tonight. turns over no start, threw code p0340 again. should i put old cam sensor back on and see if it helps?? could there be something wrong with new computer?? |
|
|
POST REPLY TO THIS THREAD |
|
|