Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
| Latest | 0 Rplys |
08-18-2012, 03:53 PM | #91 | |
AF Newbie
Join Date: Aug 2012
Location: Riverside, California
Posts: 13
Thanks: 0
Thanked 2 Times in 2 Posts
|
Re: Airtex Fuel Pumps - Buyer Beware
Darn dirty job, 3 1/2 hours for a Olds Bravada: 1) siphoning gas from tank; 2) jacking up the car; 3) removing the spare tire; 4) unplugging about 1/2 hoses that had confusing fasteners; 5) sliding a floor jack under the tank; 6) removing two screws from the harnesses that secure the tank to the frame; 7) tapping off the securing bracket; 8) removing the piece of $hit Airtex fuel filter; then, aligning the tank under the car on top of a floor jack with a 2x4 and securing it.
The dealer wanted $1500 to perform a 3 1/2 job. If you don't mind getting dirty and investing about 4 hours to do the job yourself to save a bunch of dough, then you can do it. This is the 2nd time I've done it and it wasn't any easier than the first time, however, I was prepared for the problems I encountered last time, i.e., re-installing the tank back. Good luck grasshoppers. |
|
The Following User Says Thank You to SurfBeat For This Useful Post: |
Rick Norwood (08-22-2012)
|
08-19-2012, 09:23 AM | #92 | ||
AF Fanatic
Join Date: Oct 2007
Location: EVERETT, Massachusetts
Posts: 10,898
Thanks: 8
Thanked 432 Times in 431 Posts
|
Re: Airtex Fuel Pumps - Buyer Beware
Quote:
with difficult tank removals to access the fuel pump the cutting of a hole above the fuel pump to access this pump is done more than you may be aware of. with some heavy galvanized sheet metal you can make a cover. using short self taping screws and a sealer for a gasket this makes future repairs much easier. this is done even at the dealership. many internet info about those who have done this , with pictures . |
||
08-20-2012, 09:25 AM | #93 | ||
Big Tall Dumb Ass
Thread starter
Join Date: Dec 2003
Location: Deep Dark Doo-Doo
Posts: 1,300
Thanks: 15
Thanked 27 Times in 26 Posts
|
Re: Airtex Fuel Pumps - Buyer Beware
Quote:
__________________
"If everyone is thinking alike, then no one is thinking". - Gen. George S. Patton Jr. |
||
08-27-2012, 01:50 PM | #94 | |
AF Newbie
Join Date: Aug 2012
Location: Riverside, California
Posts: 13
Thanks: 0
Thanked 2 Times in 2 Posts
|
Re: Airtex Fuel Pumps - Buyer Beware
J-Cat, I was thinking about cutting a hole just as you suggested, however, I figured it would be my luck to cut through the f'n tank, then I really would be screwed, spending the day at a junk yard looking for a replacement.
After I installed the fuel pump a few days later the problem returned; 2 - 3 cranks to get the engine started. Surprising, it cranks over easily in the morning. I am now wondering if my fuel filter is part the problem, or maybe a fuel vacuum line had a hole in it which I did not see when I removed the tank? Whatever, maybe the time has come to replace the 01 Bravada for a 11 Subaru Outback? I hate to do that because I like the size of the Bravada in contrast to the new SUV's that are just to darn big and the Subaru was the only small SUV that has the power to two my Kawi Jet Ski's to the River. Decisions, decisions. That said, the gas gauge no longer acts like a windshield wiper and it accurately reflects the amount of gas in the tank. |
|
08-29-2012, 06:07 PM | #95 | |
Big Tall Dumb Ass
Thread starter
Join Date: Dec 2003
Location: Deep Dark Doo-Doo
Posts: 1,300
Thanks: 15
Thanked 27 Times in 26 Posts
|
Re: Airtex Fuel Pumps - Buyer Beware
SurfBeat, You absolutely should replace your Fuel Filter. Look at this thread and you'll see why. http://www.automotiveforums.com/vbul....php?t=1058250
However, as far as taking 2-3 cranks to fire, when did you last do a tune up? Plugs, wires, Distributor Cap and Rotor. If it has been a while, you might start with these first.
__________________
"If everyone is thinking alike, then no one is thinking". - Gen. George S. Patton Jr. |
|
08-30-2012, 07:50 PM | #96 | |
AF Newbie
Join Date: Aug 2012
Location: Riverside, California
Posts: 13
Thanks: 0
Thanked 2 Times in 2 Posts
|
Re: Airtex Fuel Pumps - Buyer Beware
I replaced plugs and distributor cap in February 2012.
Today I noticed a gas leak - the darn filler neck that connects to the tank has a small crack. When I was taking the hose off I thought that could be a problem. An eleven year old car made by GM (Government Motors) that has lots of parts made of plastic - I should have expected problems. Saturday I am off to the junk yard to find a replacement fuel tank. Then, it is time to find a replacement for the Bravada - a Subaru Outback or Forester. Those were the only four bangers that enable me to tow my Jet Ski's. |
|
08-31-2012, 07:02 AM | #97 | ||
AF Fanatic
Join Date: Oct 2007
Location: EVERETT, Massachusetts
Posts: 10,898
Thanks: 8
Thanked 432 Times in 431 Posts
|
Re: Airtex Fuel Pumps - Buyer Beware
Quote:
works very good, 5 min cure. the other product would be marine tex. this epoxy requires about 24 hrs at 70 deg f to cure but very durable especially if used with fiberglass cloth . works excellant on oil pans also. |
||
08-31-2012, 04:54 PM | #98 | |
AF Newbie
Join Date: Aug 2012
Location: Riverside, California
Posts: 13
Thanks: 0
Thanked 2 Times in 2 Posts
|
Re: Airtex Fuel Pumps - Buyer Beware
I was going to try to epox, then I found a gas tank for $75 at the junk yard and to be on the safe side I bought it. Zero leaks, but I my problem still exists - 2 -3 cranks to crank over the Bravada.
Tomorrow I am tossing out the Auto Zone distributor cap, rotor, Champion plugs I bought in February and replacing them with AC Delco. Throw in some new plug wires. Maybe an oxygen sensor. Better yet, maybe toss out the GM car and get me a Subaru? |
|
09-01-2012, 03:49 PM | #99 | ||
AF Fanatic
Join Date: Oct 2007
Location: EVERETT, Massachusetts
Posts: 10,898
Thanks: 8
Thanked 432 Times in 431 Posts
|
Re: Airtex Fuel Pumps - Buyer Beware
Quote:
|
||
09-04-2012, 07:49 AM | #100 | |
Big Tall Dumb Ass
Thread starter
Join Date: Dec 2003
Location: Deep Dark Doo-Doo
Posts: 1,300
Thanks: 15
Thanked 27 Times in 26 Posts
|
Re: Airtex Fuel Pumps - Buyer Beware
Been There, done that, Bought the T-Shirt.
http://www.automotiveforums.com/vbul...d.php?t=975186 AC-Delco is the only way to go!
__________________
"If everyone is thinking alike, then no one is thinking". - Gen. George S. Patton Jr. |
|
10-19-2012, 09:28 PM | #101 | |
AF Newbie
Join Date: Oct 2012
Location: Wright City, Missouri
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: Airtex Fuel Pumps - Buyer Beware
If you're seriously thinking about getting one, I suggest you check out the articles on Subaru Head Gasket Failures.
Dealers are simply replacing the gaskets, and they keep on failing, until someone takes the time to drop the motor, mill the cyl and heads FLAT, then install the upgraded gaskets. The Dealers just keep you coming back so they can charge you all that labor. Other than the head gaskets, the Outback is a fine vehicle. |
|
10-21-2012, 03:11 PM | #102 | ||
AF Newbie
Join Date: Aug 2012
Location: Riverside, California
Posts: 13
Thanks: 0
Thanked 2 Times in 2 Posts
|
Re: Airtex Fuel Pumps - Buyer Beware
Quote:
|
||
10-21-2012, 03:25 PM | #103 | |
Advisor/Moderator
Join Date: Nov 2005
Location: Belleville, Michigan
Posts: 5,184
Thanks: 6
Thanked 103 Times in 95 Posts
|
Re: Airtex Fuel Pumps - Buyer Beware
If you know the dependability record of the Toyota, why are you considering buying one?
__________________
You have to know how it works, to figure out why it doesn't. |
|
10-22-2012, 12:41 PM | #104 | ||
AF Newbie
Join Date: Aug 2012
Location: Riverside, California
Posts: 13
Thanks: 0
Thanked 2 Times in 2 Posts
|
Re: Airtex Fuel Pumps - Buyer Beware
Quote:
On that note, my GM Olds Bravada required the following parts replacements: 1) two starters; 2) one fuel pump; 3) Intake Manifold Gasket; 3) Engine Cooler Lines; 4) Transfer Case Rear Seal; 5) interior plastic parts breaking; 6) interior squeaks like a pig. Now, albeit my Bravada could pass for new in appearance, on its best day I could only put a for sale sticker on it in the amount of $3300, however, a Toyota Highlander in the same condition reaps more than twice that amount, $7600. I can't recall how much more a Toyota Highlander cost in 2001 than my Olds Bravada, however, I doubt it was almost 5K more? If both SUV's were about the same in price when new, then, the Toyota was the better buy, however, if the Toyota was 5K more, then, considering my repair costs for my Bravada since 2001 were about a grand, then, the Bravada wins by 4k. Just some thoughts. |
||
10-22-2012, 05:28 PM | #105 | |
AF Fanatic
Join Date: Oct 2007
Location: EVERETT, Massachusetts
Posts: 10,898
Thanks: 8
Thanked 432 Times in 431 Posts
|
Re: Airtex Fuel Pumps - Buyer Beware
I am a GM owner since 1967. working on vehicle #4. GM has been designing vehicles for failure mileage and years of life.
with the vehicles others have owned family members etc. Toyota appears to be designed for better performance and life. Now in todays market GM quality and durability is falling. my next vehicle looks like a Toyota. having looked into reliability and dealership help with the small vehicle issues of family member Toyota vehicles I find they are far better than GM. GM is just out to screw us ! |
|
|
POST REPLY TO THIS THREAD |
|
|