Automotive Forums .com - the leading automotive community online! Automotive Forums .com - the leading automotive community online!
Automotive Forums .com - the leading automotive community online! 
-
Latest | 0 Rplys
Go Back   Automotive Forums .com Car Chat > Chevrolet > Malibu
View Poll Results: Was this helpful?
No. 1 6.67%
Yes, as originally written. 11 73.33%
Yes, with added replies used in conjunction. 3 20.00%
Voters: 15. You may not vote on this poll

Reply Show Printable Version Show Printable Version | Email this Page Email this Page | Subscription Subscribe to this Thread
 
Thread Tools
Old 11-29-2004, 01:52 PM   #1
BeatnikTermite
AF Regular
 
Join Date: May 2004
Location: Wilberforce, Ohio
Posts: 141
Thanks: 0
Thanked 3 Times in 2 Posts
How To: Radio Reception; FM=bad, AM=None

This has been discussed many times here before, and I thought I would bring all of the information together in a "how-to." I have not had to do this personally, but nobody rides in the passenger seat of my car to make it necessary.

Problem: Radio Reception is bad to non-existant. AM is usually worse than FM.

Reason: Antenna connector has come loose, and needs to be reconnected. This happens when a passenger pushes the carpet toward the firewall and disconnects the plug.

Affected Model Years: 1997, 1998, 1999, 2000, 2001, 2002, 2003

Permanent Fix:

1. First check to make sure the antenna at the back of the radio has not come loose.
2. Remove the plastic cover on the front passenger door threshold held in place by three pressure clips.
3. Peel back the carpet on the front seat passenger floor.
4. Locate the coax antenna cable running along the side.
5. Reconnect the two pieces of antenna that have come loose.
6. Roll the carpet back, and re-install the threshold cover.

Last edited by BeatnikTermite; 11-29-2004 at 02:25 PM.
BeatnikTermite is offline   Reply With Quote
The Following User Says Thank You to BeatnikTermite For This Useful Post:
jaredaj2012 (05-02-2012)
Old 08-15-2005, 10:58 AM   #2
MyBluMalibu
AF Newbie
 
Join Date: Aug 2005
Location: Clarksville, Tennessee
Posts: 5
Thanks: 0
Thanked 0 Times in 0 Posts
Send a message via AIM to MyBluMalibu Send a message via MSN to MyBluMalibu Send a message via Yahoo to MyBluMalibu
Re: How To: Radio Reception; FM=bad, AM=None

I just want to first off say thank you for the responses that I have received!! My husband and I have been trying to figure this radio situation thing out for some time now!!! We never even knew that these forums were out there! So thank you all for your replies!!!!!!!
MyBluMalibu is offline   Reply With Quote
Old 11-28-2005, 06:37 PM   #3
jwebber
AF Newbie
 
Join Date: Nov 2005
Location: rosemount, Minnesota
Posts: 4
Thanks: 0
Thanked 0 Times in 0 Posts
Re: How To: Radio Reception; FM=bad, AM=None

Quote:
Originally Posted by BeatnikTermite
This has been discussed many times here before, and I thought I would bring all of the information together in a "how-to." I have not had to do this personally, but nobody rides in the passenger seat of my car to make it necessary.

Problem: Radio Reception is bad to non-existant. AM is usually worse than FM.

Reason: Antenna connector has come loose, and needs to be reconnected. This happens when a passenger pushes the carpet toward the firewall and disconnects the plug.

Affected Model Years: 1997, 1998, 1999, 2000, 2001, 2002, 2003

Permanent Fix:

1. First check to make sure the antenna at the back of the radio has not come loose.
2. Remove the plastic cover on the front passenger door threshold held in place by three pressure clips.
3. Peel back the carpet on the front seat passenger floor.
4. Locate the coax antenna cable running along the side.
5. Reconnect the two pieces of antenna that have come loose.
6. Roll the carpet back, and re-install the threshold cover.

Well, on my 2000 Malibu, the radio reception will sound fine, but when I adjust the volume dials only slightly, the reception goes out. Then if I crank the volume, it sounds OK again. I checked my floor antenna connection and it is fine. Could my problem be the radio dials? If so, how do I remove them? Thanks for any advice.
jwebber is offline   Reply With Quote
Old 10-30-2006, 02:42 PM   #4
CBriggs9
AF Newbie
 
Join Date: Oct 2006
Location: Williamsport, Pennsylvania
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
Re: How To: Radio Reception; FM=bad, AM=None

Thank You, Thank You, Thank You. After numerous searches and never ending technical mumbo jumbo the solution ended up being so simple. I must have looked at hundreds of sites talking about modulators, rear window antennas and tinting, antenna grounding etc., and the solution was sitting un-attached under my passenger seat carpet. Plugged it back in and works like new!
CBriggs9 is offline   Reply With Quote
Old 10-31-2006, 06:08 PM   #5
MalibuBob
AF Newbie
 
Join Date: Jun 2006
Location: Cos, Colorado
Posts: 53
Thanks: 7
Thanked 0 Times in 0 Posts
Re: How To: Radio Reception; FM=bad, AM=None

Quote:
Originally Posted by jwebber
Well, on my 2000 Malibu, the radio reception will sound fine, but when I adjust the volume dials only slightly, the reception goes out. Then if I crank the volume, it sounds OK again. I checked my floor antenna connection and it is fine. Could my problem be the radio dials? If so, how do I remove them? Thanks for any advice.
Do you lose reception or just volume? It would be pretty tough for anything you do with the volume control to affect reception, however, a bad volume control could cause the sound to disappear and re-appear. You'll need a shop to check the volume control.
MalibuBob is offline   Reply With Quote
Old 06-13-2007, 07:05 PM   #6
fisherdm
AF Newbie
 
Join Date: Sep 2006
Location: Schertz, Texas
Posts: 17
Thanks: 0
Thanked 0 Times in 0 Posts
Re: How To: Radio Reception; FM=bad, AM=None

This fix was right on. It was also so easy (took me 5 minutes) I feel like an idiot for driving around for 2+ years only listening to CDs in my car.
fisherdm is offline   Reply With Quote
Old 07-11-2007, 08:59 AM   #7
videobruce
AF Newbie
 
Join Date: May 2005
Location: Buffalo, New York
Posts: 97
Thanks: 6
Thanked 0 Times in 0 Posts
Re: How To: Radio Reception; FM=bad, AM=None

The AM band is affected first because of is wavelength. 1 MHz vs 100 MHz (center frequencies) makes a huge difference. Measure with a decent DVM the resistance between chassis ground and the shield of the antenna cable at the radio. Then measure resistance between the center conductor and the 'whip' of the antenna. Some antennas use a wire that wraps around the of the 'whip' (if you can make contact, you might have to break the coating to do so). Both readings should be well under 5 ohms especially the ground.
__________________
When not in use,turn off the juice!
videobruce is offline   Reply With Quote
Old 02-03-2010, 02:59 PM   #8
thusted
AF Newbie
 
Join Date: Dec 2004
Location: rochester, Alabama
Posts: 11
Thanks: 0
Thanked 0 Times in 0 Posts
Re: How To: Radio Reception; FM=bad, AM=None

thank you - I was going to pull the dash to check the radio/antenna connection, and thought I would check this forum first. Very easy fix, saved me alot of time.

and thanks to everyone who contributes to these forums. Thanks for sharing your knowledge to help all of us save money and stress!
thusted is offline   Reply With Quote
Old 05-20-2011, 02:37 PM   #9
aem1988
AF Newbie
 
Join Date: May 2011
Location: Lubbock, Texas
Posts: 3
Thanks: 0
Thanked 0 Times in 0 Posts
Re: How To: Radio Reception; FM=bad, AM=None

Hi, could you tell me more about this plastic cover that I need to remove? It says it is located on the passenger side door threshold. I'm not sure what this is. Thanks!
aem1988 is offline   Reply With Quote
Old 05-20-2011, 03:14 PM   #10
inafogg
AF Enthusiast
 
Join Date: Jul 2007
Location: claymont, Delaware
Posts: 1,744
Thanks: 10
Thanked 57 Times in 56 Posts
Re: How To: Radio Reception; FM=bad, AM=None

Quote:
Originally Posted by aem1988 View Post
Hi, could you tell me more about this plastic cover that I need to remove? It says it is located on the passenger side door threshold. I'm not sure what this is. Thanks!
the threshold is the metal trim at the bottom of the door opening
has screws holding it down,remove this to access carpet

Good luck
__________________
Live For Today
Yesterday is gone,
Tomorrows are'nt promised.
inafogg is offline   Reply With Quote
The Following User Says Thank You to inafogg For This Useful Post:
jaredaj2012 (05-02-2012)
Old 05-20-2011, 03:21 PM   #11
aem1988
AF Newbie
 
Join Date: May 2011
Location: Lubbock, Texas
Posts: 3
Thanks: 0
Thanked 0 Times in 0 Posts
Re: How To: Radio Reception; FM=bad, AM=None

Thanks! Totally fixed it now
aem1988 is offline   Reply With Quote
Old 05-02-2012, 04:04 PM   #12
jaredaj2012
AF Newbie
 
Join Date: May 2012
Location: Middleboro, Massachusetts
Posts: 1
Thanks: 2
Thanked 0 Times in 0 Posts
Talking Re: How To: Radio Reception; FM=bad, AM=None

THANK YOU SO MUCH! I have been struggling without my radio in my car. My Jeep had perfect reception and sounded beautiful, and then I bought my 99 Malibu and was devastated because, even though it had only 79k miles and much better gas mileage, it had no radio! Now, I do! Muchos gracias!
jaredaj2012 is offline   Reply With Quote
Old 07-18-2013, 04:48 PM   #13
tdrexel
AF Newbie
 
Join Date: Jul 2013
Location: Livermore Falls, Maine
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
Re: How To: Radio Reception; FM=bad, AM=None

Well age takes it's toll. I read the post on poor radio reception on my 2000 Malibu. Thanks for mentioning the antenna wire coupling just front of the passenger front door and under the rocker panel cover and carpet. I read it and the light came on I remember that from older GM cars back to the 70s. I removed the plastic cover, lifted the carpet found the coupling, YUP, wire was uncoupled, plugged it back in GREAT RECEPTION. YOU THE MAN Thanks!!!
tdrexel is offline   Reply With Quote
Old 03-25-2016, 09:34 PM   #14
Anniecowgirl
AF Newbie
 
Join Date: Mar 2016
Location: Coarsegold, California
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
Re: How To: Radio Reception; FM=bad, AM=None

I have found the antenna cable in my 1999 malibu, but I can't find where I'm suppose to connect it.
Anniecowgirl is offline   Reply With Quote
Old 07-10-2017, 07:18 PM   #15
ssmorby
AF Newbie
 
Join Date: Dec 2007
Location: Canton, Michigan
Posts: 7
Thanks: 0
Thanked 0 Times in 0 Posts
Re: How To: Radio Reception; FM=bad, AM=None

Thanks for the post. On my 2003 Impala the reception on both was poor. I pulled the passenger side trim and looked under the carpet but no coax cable. I noticed extra connection to the rear defrost/antenna on the drivers side so I pulled the trim and peeled back the carpet. There was the coax cable mentioned on the drivers side. So if you don't find under passenger side look on drivers side.
__________________
ssmorby
ssmorby is offline   Reply With Quote
 
Reply

POST REPLY TO THIS THREAD

Go Back   Automotive Forums .com Car Chat > Chevrolet > Malibu

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 10:17 PM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts