Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
| Latest | 0 Rplys |
03-18-2004, 01:02 AM | #1 | |
AF Enthusiast
Join Date: Jan 2002
Location: playa mexico
Posts: 2,958
Thanks: 0
Thanked 2 Times in 2 Posts
|
torsion bars on 84
I got an 84 nissan king cab 4x4 5 speed today, I did the usual tune-up like plugs/wires/air filter/oil and filter, and I am gonna get the cap and rotor tomorrow. I am thinking of getting a carb rebuild kit also since it was sitting for a long time. and I am getting this BL off of ebay, but was just wondering about cranking the torsion bars for a bit more lift. I am gonna get 2 inch blocks in the rear, and then a 3 inch BL, and I am gonna crank up the torsion bars to get a couple inches of lift in the front. but I am wondering if the truck sits level now(it is bone stock) and I wanna lift it evenly is one side heavier to where I will need to say crank the passenger side bolt a few more turns or the drivers side bolt 10 more turns???
and where can I get a set of gears for this thing, I wanna run bigger tires but its already underpowered so I dont wanna get huge tires until I can gear down as well.
__________________
current -84 datsun 720 4x4(2nd time)-93 accord-90 camry V6-90 warrior-94 300ex history: -01 R1-04 daytona 600-94 teg RS-95 teg LS -91 teg RS-92 teg GSR-94 civic CX hatch (3 times) -94 civic DX-96 civic HX-97 Accord LX-72 superbeetle -74 beetle-84 silverado-66 c10-74 maverick-78 280z -84 200sx-86 tercel wagon-95 mustang V6 |
|
|
POST REPLY TO THIS THREAD |
|
|