Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
| Latest | 0 Rplys |
|
Show Printable Version | Email this Page | Subscribe to this Thread |
|
Thread Tools |
02-06-2017, 07:01 AM | #1 | |
AF Newbie
Join Date: Feb 2017
Location: Binghmton, New York
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
|
1998 Lincoln Continental Wiper Control Module
In a previous Post Towncar advised an individual with non functioning wipers to not attempt to replace the wiper control module as a DIY project since once installed the module had to be coded.
I replaced the engine in my 1998 and when I started and checked out the car everything worked except the iwipers (but the washer worked). I checked the fuse (Number 10) -good Checked motor connector 13.4 V resistance reading varied but not in accordance with recommended readings Checked the switch all readings (with and without rotation of switch) met recommended resistance recommendations. Replaced the wiper motor as a precaution with new motor and still no wipers QUESTION: If as Towncar stated, the Control Module has to be coded when installed/reinstalled does it work the other way: Wherein replacement of an engine would require recoding of the module? IF that is not required then can someone tell me how to access the module - removed left paneling, removed center console (Radio/Heat), could not figure out how to remove right lower dash paneling. Can anyone advise on thwat or at least verify where the module is located - could not find it on internet. ANY/ALL advice welcome |
|
|
POST REPLY TO THIS THREAD |
Thread Tools | |
|
|