Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
| Latest | 0 Rplys |
|
Show Printable Version | Email this Page | Subscribe to this Thread |
|
Thread Tools |
11-06-2008, 07:35 PM | #16 | ||
AF Newbie
Thread starter
Join Date: Oct 2008
Location: Kingston
Posts: 36
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: 97 Malibu V6 3.1L ABS Light Always On
Quote:
I kind of found the location of the EBCM, which is located in the inner splash board of the driver's side front wheel. Should I remove the EBCM unit then measure the connectors in the box that holding the EBCM unit? Please advise. Thank you! |
||
11-07-2008, 09:14 AM | #17 | |
A990 racer
Join Date: Mar 2002
Location: Chestertown, New York
Posts: 16,952
Thanks: 25
Thanked 371 Times in 365 Posts
|
Re: 97 Malibu V6 3.1L ABS Light Always On
This can be a tough job to pinpoint the 2 wires for each wheel sensor and check continiuty in the harness back to the sensor, you must use a long jumper, of course, to each sensor wire.
__________________
|
|
11-07-2008, 10:28 AM | #18 | ||
AF Newbie
Thread starter
Join Date: Oct 2008
Location: Kingston
Posts: 36
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: 97 Malibu V6 3.1L ABS Light Always On
Quote:
Glad to hear from you! Would it be feasible to measure the resistance between two connectors at the bracket box of the EBCM Unit? If the resistance of 4 pairs of connectors to the 4 ABS sensors are close the the resistance of the sensors, then the connectivity might be ok, otherwise there is a open or short. Please advise, thank you! |
||
11-07-2008, 02:10 PM | #19 | |
A990 racer
Join Date: Mar 2002
Location: Chestertown, New York
Posts: 16,952
Thanks: 25
Thanked 371 Times in 365 Posts
|
Re: 97 Malibu V6 3.1L ABS Light Always On
The resistance will be higher of course, but I don't know how much over that length of harness, but if is way out of whack you know there is an issue in that circuit.
__________________
|
|
|
POST REPLY TO THIS THREAD |
|
|