Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
| Latest | 0 Rplys |
|
Show Printable Version | Email this Page | Subscribe to this Thread |
|
Thread Tools |
05-22-2008, 01:59 PM | #1 | |
AF Newbie
Join Date: May 2008
Location: Auckland
Posts: 4
Thanks: 0
Thanked 0 Times in 0 Posts
|
torque wrench setting for 2 litre zetec crankshaft pulley bolt
Hi, am preparing to renew the timing belt on our year 2000 Mondeo. I have the Haynes Service & Repair Manual #1923 which is very good but does not seem to include the torque wrench setting for the crankshaft pulley bolt. Does anyone have the correct setting for this?
The last cambelt I did on a 2 litre engine was a Honda CR-V, for which the crankshaft pulley bolt torque wrench setting was 177 N.m [or 130 ft-lbs]. So the Mondeo setting will probably not be too far from that, although I have not checked the exact diameter of the bolt yet. Thanks. |
|
|
POST REPLY TO THIS THREAD |
|
|