 |
 |
 |
|
|
 |
| Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
 | | ||
| |
|
| Latest | 0 Rplys |
|
|||||||
 |
 Show Printable Version |  Email this Page | 
Subscribe to this Thread
|
|
|
Thread Tools |
06-19-2006, 04:08 PM
|
#1 | |
|
AF Newbie
 Join Date: Aug 2004
Location: Wilmin, Kentucky
Posts: 32
Thanks: 0
Thanked 0 Times in 0 Posts
|
'95 2.4L 22RZ throttle adjustment?
hi guys,
I recently had to adjust the throttle plate out by adjusting the throttle stop screw because it was physcially hitting the throttle body and was causing it to "stick". Before I bust out the ohm-meter and test the TPS is still in sync, how far out should this throttle set screw be set? If I were to guess I would say to the idle spec (650-750) but I'm really not sure. Any thoughts? And does any know of a way to test engine rpm with just a multimeter? |
|
|
|
|
06-19-2006, 07:38 PM
|
#2 | |
|
AF - Advisor
 
Join Date: Oct 2004
Location: Tacoma, Washington
Posts: 686
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: '95 2.4L 22RZ throttle adjustment?
Which screw are you refering to. Are you talking about the throttle opener screw? You set the inital with a feeler gauge. When the throttle closed it should be .026 in. Then you do your adjustment.
For engine RPM there are special automotive multimeters that have an RPM setting. |
|
|
|
|
|
06-19-2006, 08:19 PM
|
#3 | |
|
AF Newbie
Join Date: Aug 2004
Location: Wilmin, Kentucky
Posts: 32
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: '95 2.4L 22RZ throttle adjustment?
Yes the throttle opener screw. .026 in from what to what? I know you need about that much when you adjust the TPS (set screw to TB) but I need to know where that set screw is supposed to be set at so the throttle valve itself is in the right position to adjust the TPS to. Could you be a little more clear?
|
|
|
|
|
|
06-19-2006, 08:46 PM
|
#4 | |
|
AF - Advisor
Join Date: Oct 2004
Location: Tacoma, Washington
Posts: 686
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: '95 2.4L 22RZ throttle adjustment?
When the throttle is closed measure the gap between the throttle stop and the screw with a feeler gauge. The gap should be .026 inches.
|
|
|
|
|
|
06-19-2006, 09:21 PM
|
#5 | |
|
AF Newbie
Join Date: Aug 2004
Location: Wilmin, Kentucky
Posts: 32
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: '95 2.4L 22RZ throttle adjustment?
ah ok. Thats completely the opposite of what I have it at now. Its probably about an eigth of an inch the other way...at least.
Thanks for the help. |
|
|
|
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
