New to Panoz - brake and other help

[Tntgolden]

Just bought 2006 GTS - New to Panoz so any or all help appreciated - has been stored for the last couple of years and am looking to get it back on the track for track days - was planning to change all fluids, bearings, front spindles, brake rotors and pads - brembro rotors avail for the front (expensive) but not the rears - was considering having Coleman making a set all the way around - any experience? they said they would save template does anyone have them saved? has anyone had them make hats? has anyone had them make spindles?
any other tips/tricks welcomed
Thanks!!

[rioredstang]

I need some rotors also. Maybe we could get a group buy.

[Tntgolden]

Im sure they would work with us - they indicated once they make measurements they save them to make duplicates - not decided if I am going to have them make hats also - they can also make spindles - spindles are available from Panoz - I was planning to replace them - Panoz replaced them yearly on the school cars - the originals have been known to break which can be catastrophic.

[panozracing]

I have broken many spindles. Definitely change them and track age etc.

I would not get coleman anything for the brakes unless you are not running 10/10ths. They are not nearly as strong as Brembo etc.

[Tntgolden]

Brian - thank you - will replace the spindles ASAP - the brembro fronts are available ($475 a pop) but I can't find the rears - do you have a source or part number - I have been told to change the disc hardware at the same time and inspect the hats closely - love the picture - sexy beast! Thad

[panozracing]

Front Rotors - 099226.39 & 099226.49 - 328x32mm
Rear Rotors - 095682.50 & 095682.60 - 320x28mm
Front Hat 90.129
Rear Hat 80.1047

Hardware per Wheel
Long Bobbin X20.30.26 - 8mm
Long Bolt A1.68.3J.105
Short Bobbin X80.20.08 - 6mm
Bolt Bolt A1.68.3J.103
Washer 05579320


Rear hub to hat upgraded hardware (recommended with safety wire...I break these) (also available from Panoz where I get them):
McMAsters - 92562A304 - MIL Spec Alloy Steel Socket Head Cap Screw, Cadmium plated, 5/16"-18 Thread, 1" L, Ms16997-80, Packs of 1

[bbenavitz]

I have purchased Coleman made rotors (just the ring not aluminum hat) twice and happy with the results. They give you a spec sheet to fill out and the turn around time is about 4 days at $250 each. I have the specs if you want to go this route. email is bill.benavitz@arthrex.com