Automotive Forums .com - the leading automotive community online! Automotive Forums .com - the leading automotive community online!
Automotive Forums .com - the leading automotive community online! 
-
Latest | 0 Rplys
Go Back   Automotive Forums .com Car Chat > Hyundai > General Discussion
Reply Show Printable Version Show Printable Version | Email this Page Email this Page | Subscription Subscribe to this Thread
 
Thread Tools Search this Thread
Old 06-20-2020, 05:23 PM   #1
Jacob42
AF Newbie
 
Join Date: Jul 2018
Location: Lehi, Utah
Posts: 4
Thanks: 0
Thanked 0 Times in 0 Posts
Welding on transmission

I'm working on a 2001 Hyundai Accent with the manual trans and the throwout bearing sleeve got cut off in a catastrophic failure of the throwout bearing and pressure plate. There is still about 1/2 inch attached and I was planning to grind it down enough to allow an aluminum pipe with the same outer diameter to slide over it then braze it to the housing. My question is do you think the high temps needed for brazing (700F) would damage the input shaft seal that is located directly behind it? Should I attempt to use JB weld instead?

Here is a picture of the damage
https://drive.google.com/file/d/1Vwb...ew?usp=sharing
Jacob42 is offline   Reply With Quote
 
Reply

POST REPLY TO THIS THREAD


Bookmarks
Go Back   Automotive Forums .com Car Chat > Hyundai > General Discussion

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 04:45 AM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts