How can I tune my P11?

[pedgren]

I got a -00 Primera sport and I wouldn´t mind if it where a little "hotter". Do you have any suggestions of how to tune it?

[SashaSR20DE]

Hi Pedgren,
What kind of P11? There ar two P11´s
One P11 96-99.9 and the P11 144 (facelift) 99 - 01.

I think you should go to:
http://www.nissanprimera.net/
http://www.sr20forum.com/
http://www.nissanforums.com/

If you need any more info just ask!!

You are not alone with a primera!!!

Jag såg at du är svensk, så du kan även skriva på svenska till mig om du vill. Välkommen till den underbara världen an Nissan Primera!!

[alimcb]

Advance the ignition timing? Not sure exactly how many degrees before TDC is the optimum, I think it's about 17. However you'll need to run the car on higher grade fuel - 97 or 98 octane, like Optimax. If the engine management appears to be retarding the power after you do this (esp in high ambient temperatures) then you've overdone it.

I tried Optimax alone without changing ignition timing and there was no perceptible difference in performance, although an extra mile or two per gallon and a smoother idle were two benefits. Against standard unleaded, the extra 8-10p per litre wasn't worth it so I'm back to filling up with normal unleaded.

[SeanSmith]

Some basic stuff:

Fit a catback exhaust system - if you have the CVT/M6 transmission this will make it pull much better and cleaner from a standing start.

Fit a K&N filter - you can fit a drop in K&N which will give you a couple of extra horspower but you'd be better pulling out the existing airbox and fitting a complete new K&N cone filter. In front of the existing airbox is a black pipe (between the airbox and the headlights) - leave this pipe in place. It has the cold air temp sensor mounted in it plus it is useful as it feeds cold air right to where your new cone filter will sit.

As already said - advance the timing a little - this will bring your power further down the rev range and will give you quicker pullaway. Run your car on Optimax though as it's a higher octane.

Those are the easiest quickest mod's to fit. You can go further and fit cam's, etc but your talking bigger money and if it's just a little extra fun and drivability you want then the mod's above will get you going nicely. One downside to fitting cams is that they take power away from the lower rev range and add it on higher up the revs. That's fine for a manual gearbox car as you can fit a wild cam and pull away at higher revs, but for anything automatic/CVT etc you want to avoid this as you need to try pick up more in the lower rev range.

On my Chrysler Neon I also had a highstall torque converter fitted which meant you pulled away at about 2500rpm and I increased the line pressure in the transmission which gave quicker gearchanges, but I haven't looked into anything like this for the Nissan CVT/M6 yet as I know nothing about this transmission.

Hope this helps.

-=Sean=-

[alimcb]

Does anyone know the optimum ignition timing to go for with Optimax? I suggested 17 but I'm not sure if that is right.

(In Japan you can get 100 octane petrol, absolute rocket fuel!)

[iLikeMyDamnPrimera]

Originally Posted by alimcb

(In Japan you can get 100 octane petrol, absolute rocket fuel!)

I want dat gimme gimme.


How about just rip out the air filter so you have no air filter, hee hee. Talk about air flow baby. j/k.

[alimcb]

Originally Posted by iLikeMyDamnPrimera

How about just rip out the air filter so you have no air filter, hee hee. Talk about air flow baby. j/k.

I do hope you're joking...

[iLikeMyDamnPrimera]

Originally Posted by alimcb

I do hope you're joking...

what does j/k stand for?

LOL