 |
 |
 |
|
|
 |
| Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
 | | ||
| |
|
| Latest | 0 Rplys |
|
|||||||
 |
 Show Printable Version |  Email this Page | 
Subscribe to this Thread
|
|
|
Thread Tools |
09-26-2022, 04:28 PM
|
#1 | |
|
AF Newbie
Join Date: Sep 2022
Location: Woodstock
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
|
To complete a Timing Belt but I'm Stuck!
I was replacing my timing belt now...
My camshafts top dead center marks aren't aligned with my crank shaft top dead center marks. It's off by about a half inch. I can't turn the engine past a certain point now. When I took off the old belt it all matched up I may have accidentally turned them when I put on the new timing belt. What do I do? |
|
|
|
|
09-27-2022, 05:13 AM
|
#2 | |
|
Your worst nightmare
 
Join Date: Oct 2004
Location: Smithfield, Pennsylvania
Posts: 6,055
Thanks: 40
Thanked 252 Times in 246 Posts
|
Re: To complete a Timing Belt but I'm Stuck!
Take the belt back off and start over.
__________________
|
|
|
|
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
