Automotive Forums .com - the leading automotive community online! Automotive Forums .com - the leading automotive community online!
Automotive Forums .com - the leading automotive community online! 
-
Latest | 0 Rplys
Go Back   Automotive Forums .com Car Chat > Buick > Park Avenue
Reply Show Printable Version Show Printable Version | Email this Page Email this Page | Subscription Subscribe to this Thread
 
Thread Tools
Old 10-24-2016, 07:33 AM   #1
rshayes
AF Newbie
 
Join Date: Oct 2016
Location: Pendleton, Indiana
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
Buick Park Avenue engine smoking

We have a 2000 Buick Park Avenue that was losing a lot of coolant. My husband has replaced the radiator, thermostat, lower intake manifold and the lower and upper manifold gaskets. After all this, there is white smoke and an oil burning smell coming from around the oil reservoir. He is prepared to change the head gaskets next. Is there anything else this could be or that should be checked?

The engine began smoking after the radiator and thermostat repair, which prompted the intake manifold gasket repair. There have not been any codes or overheating, according to the dash read-out.

Any suggestions would be appreciated.
rshayes is offline   Reply With Quote
Old 10-24-2016, 07:59 PM   #2
Blue Bowtie
Registered Offender
 
Blue Bowtie's Avatar
 
Join Date: Mar 2006
Location: Rural
Posts: 6,517
Thanks: 6
Thanked 341 Times in 336 Posts
Re: Buick Park Avenue engine smoking

Did the engine overheat when it lost coolant? If so the heads and/or lower intake may be warped or cracked. A pressure test may be very revealing.

Was the oil changed after replacing the gaskets? If not the residual coolant may be boiling out of the engine oil as it heats up. Coolant is also very bad for the soft metal in engine bearing shells.
__________________
Permanent seat assignment on the Group W bench...
Automotive Forums Survival Guide
Blue Bowtie is offline   Reply With Quote
Old 10-24-2016, 08:32 PM   #3
rshayes
AF Newbie
Thread starter
 
Join Date: Oct 2016
Location: Pendleton, Indiana
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
Re: Buick Park Avenue engine smoking

Thanks for your response.
The car never seemed to overheat but our son had it at college so we aren't sure what all went on. He said it never showed that the temperature was above normal in the dash read out. It seemed to go through a lot of coolant. We went to visit and brought him a new radiator cap, hoping it was a simple issue. All the coolant we added then drained out after he drove it just a very short distance. It very well could have overheated at some point.

Anyway, my husband is in the process of changing the head gaskets. He is also putting a new water pump on while he has the engine apart. Hopefully, this will solve the issue.

It has been a great car and we would love to have it running again!
rshayes is offline   Reply With Quote
Old 10-24-2016, 08:36 PM   #4
Stealthee
Your worst nightmare
 
Stealthee's Avatar
 
Join Date: Oct 2004
Location: Smithfield, Pennsylvania
Posts: 6,052
Thanks: 38
Thanked 251 Times in 245 Posts
Re: Buick Park Avenue engine smoking

I'd look at the water pump and the coolant elbows.
__________________
Stealthee is offline   Reply With Quote
Old 10-26-2016, 06:24 AM   #5
Foolzrushn
AF Newbie
 
Join Date: Nov 2006
Location: big city
Posts: 19
Thanks: 1
Thanked 0 Times in 0 Posts
Re: Buick Park Avenue engine smoking

There are plastic and metal replacement elbows. I found out after I had used the plastic one. Don't know why they weren't always metal.

Consensus seems to be, to replace O-rings provided, with better ones. Dorman 47065HD.

Mine didn't smoke, just had coolant smell and loss. Good Luck
__________________
1998 Park Avenue Ultra
Foolzrushn is offline   Reply With Quote
Old 10-26-2016, 05:11 PM   #6
Tech II
AF Fanatic
 
Join Date: Jul 2011
Location: Worcester, Massachusetts
Posts: 5,017
Thanks: 70
Thanked 618 Times in 610 Posts
Re: Buick Park Avenue engine smoking

Did you check for plastic degradation in the upper plenum where the egr tube passes through it? The tube can contact the plenum and heat it so it melts, creating a hole.......usually when this happens, when you take the upper plenum off the lower intake, the cavities of the lower intake are full of coolant...
Tech II is offline   Reply With Quote
 
Reply

POST REPLY TO THIS THREAD

Go Back   Automotive Forums .com Car Chat > Buick > Park Avenue

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 02:19 PM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts