Automotive Forums .com - the leading automotive community online! Automotive Forums .com - the leading automotive community online!
Automotive Forums .com - the leading automotive community online! 
-
Latest | 0 Rplys
Go Back   Automotive Forums .com Car Chat > Ford > F Series
F Series Forum covers questions and discussions regarding Ford F-150, Ford F-250, Ford F-350, Ford F-450, Ford F-550, Ford F-650, and Ford F-750.
Reply Show Printable Version Show Printable Version | Email this Page Email this Page | Subscription Subscribe to this Thread
 
Thread Tools Search this Thread
Old 05-08-2022, 08:24 PM   #1
clutch492
ASE Master Tech
 
Join Date: Jun 2005
Location: Circleville, Kansas
Posts: 88
Thanks: 6
Thanked 0 Times in 0 Posts
Ford 4.6L loss of compression in one cylinder SOLVED

After going through a nightmare with a 4.6L, I discovered that the intake valve was "cupped" which made the valve stem too long. This would not allow the valve to close completely. A quick fix is to grind off about .50" of the valve stem. Either that, or remove the head and replace the valve. This valve became deformed due to a misfire that created a lot of heat. An intake valve should not be getting that hot since there is air flowing over it all the time. After the compression was restored, the cylinder is firing normally and the valve should not deform any longer. It should last. The only way to get this cylinder to seal, with air pressure in it, was to remove the rocker arm. After measuring other heads, to see how tall the valve stem was, I determined that there was around 50 to 60 thousands of an inch more valve stem on that intake valve. I ground it down, with magnets and rags surrounding it. Put the rocker arm back on, and had compression. Happy Dance!!!

I hope this helps all of you that are struggling with this dreaded issue. It appears to be a common problem which occurs after a misfire begins. This cylinder will then have no combustion, therefore no more exhaust leaving the cylinder. The air in the cylinder, will remain in the cylinder, and get extremely hot. The intake valve is fairly thin and cannot handle the heat. After a while, it will start cupping out and the valve stem will get longer and longer until the valve will no longer close.
clutch492 is offline   Reply With Quote
 
Reply

POST REPLY TO THIS THREAD


Tags
4.6, 4.6l, compression, ford, misfire
Go Back   Automotive Forums .com Car Chat > Ford > F Series

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 02:28 AM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts