Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
| Latest | 0 Rplys |
|
Show Printable Version | Email this Page | Subscribe to this Thread |
|
Thread Tools |
03-18-2012, 12:24 PM | #1 | |
AF Newbie
Join Date: Mar 2009
Location: malibu, California
Posts: 24
Thanks: 0
Thanked 0 Times in 0 Posts
|
Did I fry my ECU !!?? Help please.
'01 3.0i auto;
This morning I was trying ton confioirm Peak code 7b (Thermostat map control) which as I understand, is related too the heating element of the main Thermostat (2 prong connector on top, just behind the top of the fan blade). To check that I was getting power to the plug/heater element, I connected my volt meter to the 2 prongs in the plug/harness side and turned the key on while watching. The meter bleeped a bit but nothing, so I dicided to start the engine and see if that would bring the power up. No start. It turns over but wouldn't start. Replugged the connetor - same. Checked all related fuses - OK. Disconnected the battery for an hour - same. Any help on something like this?? THANKS IN ADVANCE!! Worried |
|
03-13-2013, 02:32 AM | #2 | |
AF Newbie
Join Date: Oct 2012
Location: New York
Posts: 34
Thanks: 1
Thanked 4 Times in 2 Posts
|
Re: Did I fry my ECU !!?? Help please.
you need a ecu tools and you can find some good ones in xcardiag.com
i had buy some from it and they are cheap and good |
|
10-10-2013, 07:01 PM | #3 | |
AF Newbie
Join Date: Apr 2005
Location: ny, New York
Posts: 13
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: Did I fry my ECU !!?? Help please.
I broke that sensor off in the housing and its been dangling in its clip for 7 years.
Check f or other plugs you 4got to plug in. |
|
|
POST REPLY TO THIS THREAD |
Thread Tools | |
|
|