 |
 |
 |
|
|
 |
| Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
 | | ||
| |
|
| Latest | 0 Rplys |
|
|||||||
| Eighty Eight Includes the '97-'98 Regency and '96-'99 LSS Models |
 |
 Show Printable Version |  Email this Page | 
Subscribe to this Thread
|
|
|
Thread Tools |
01-03-2011, 06:51 PM
|
#1 | |
|
AF Newbie
Join Date: Nov 2007
Location: Macon, Georgia
Posts: 4
Thanks: 0
Thanked 0 Times in 0 Posts
|
Upper intake (Plenum) question 97 88 LS
I got the old plastic upper intake (plenum) off my 1997 Olds eight eight. When I took it off the gasket and everything came off. No real problem but leaves me with a question. As most know the gasket is a thick plastic gasket that has a bead on each side. Going from front to back there are two plastic supports that hold a pipe. I am guessing one end is open to the cavity and the other end goes into the hole going to the PCV is this correct? I looked in my manual and did a search online but could not find anything that confirms this. Too muck to have to take the new one off later so please advise me.
Thanks! |
|
|
|
|
01-04-2011, 04:04 PM
|
#2 | |
|
A990 racer
 Join Date: Mar 2002
Location: Chestertown, New York
Posts: 16,953
Thanks: 25
Thanked 371 Times in 365 Posts
|
Re: Upper intake (Plenum) question 97 88 LS
Correct, while you are in there, remove the 2 inside corner lower int. bolts ans seal them with rtv, oil can migrate up these bolts.
__________________
|
|
|
|
|
| ||||||||||||||||||||||||||||||||||||||
|
POST REPLY TO THIS THREAD |
 |
|
|
