Automotive Forums .com - the leading automotive community online! Automotive Forums .com - the leading automotive community online!
Automotive Forums .com - the leading automotive community online! 
-
Latest | 0 Rplys
Go Back   Automotive Forums .com Car Chat > Ford > Contour
Reply Show Printable Version Show Printable Version | Email this Page Email this Page | Subscription Subscribe to this Thread
 
Thread Tools
Old 02-16-2008, 05:11 PM   #1
mre4ever
AF Newbie
 
Join Date: Feb 2008
Location: pontiac, Illinois
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
98 contour 2.5l dohc misfire/rough idle

im new to this thread, however, i've pretty much read almost all of the contour threads on the problems these cars have. timing chain, vacuum leak, etc. Here's my problem/s.

I bought this car 2 1/2 weeks ago. ran good, no check engine light, nothing. then I started it up one day, and it ran the rpm's up to 2500 and back down to 300. If it doesn't die, then it goes back up and down several times until its warmed up. It still does it every day. Once it's warmed up it idles where it's supposed to, around 900 -1100 rpm somewhere in there, however it's still rough. I just replaced the plugs and wires, being that's the cheapest test. No change. Does the same thing. The only other problem, that I know of is that there's a small oil leak on the back valve cover. I check the oil everyday, and it isn't even 1/2 qt low in 2 1/2 weeks. Don't think that it's related to this problem. My guess is a coil pack??? or a maf sensor??? just looking for the best direction to go, without spending big $$$$ fixing this annoyance. Thanks in advance. O, I got the check engine light flashing, and the codes when read were, misfire on 1, and 3. car running to lean/rich, and o2 sensor upstream.
mre4ever is offline   Reply With Quote
Old 02-17-2008, 05:03 AM   #2
Davescort97
Escort guy
 
Join Date: Dec 2004
Location: Garfield, Arkansas
Posts: 2,486
Thanks: 0
Thanked 3 Times in 3 Posts
Re: 98 contour 2.5l dohc misfire/rough idle

Check the PCV valve and vacuum line going into the intake plenum. Sometimes the elbow develops a crack in it. Replace the PCV valve since it's only a couple bucks.
Davescort97 is offline   Reply With Quote
Old 02-17-2008, 09:47 AM   #3
beyondloadedSE
AF Ford Contour-Advisor
 
beyondloadedSE's Avatar
 
Join Date: Mar 2003
Posts: 1,815
Thanks: 0
Thanked 2 Times in 2 Posts
Re: 98 contour 2.5l dohc misfire/rough idle

Quote:
Originally Posted by mre4ever
im new to this thread, however, i've pretty much read almost all of the contour threads on the problems these cars have. timing chain, vacuum leak, etc. Here's my problem/s.

I bought this car 2 1/2 weeks ago. ran good, no check engine light, nothing. then I started it up one day, and it ran the rpm's up to 2500 and back down to 300. If it doesn't die, then it goes back up and down several times until its warmed up. It still does it every day. Once it's warmed up it idles where it's supposed to, around 900 -1100 rpm somewhere in there, however it's still rough. I just replaced the plugs and wires, being that's the cheapest test. No change. Does the same thing. The only other problem, that I know of is that there's a small oil leak on the back valve cover. I check the oil everyday, and it isn't even 1/2 qt low in 2 1/2 weeks. Don't think that it's related to this problem. My guess is a coil pack??? or a maf sensor??? just looking for the best direction to go, without spending big $$$$ fixing this annoyance. Thanks in advance. O, I got the check engine light flashing, and the codes when read were, misfire on 1, and 3. car running to lean/rich, and o2 sensor upstream.
V6's do not have problems with timing chains, so that eliminates that possibility. Youre probably thinking of the timing belt on the I4.

This problem however, is probably covered in the contour.org FAQs.

Engine idles high.
http://contour.org/FAQ/FAQ.php?s=probs&displayid=7
__________________

"The CEG Nazi"
www.contour.org
1996 Ford Contour SE - Sold
3.0L V6 and Arizona Dyno Chip Turbo Kit
364 whp, 410 wtq @ 16 psi and only 4,700 rpms.
1999 Tropic Green SVT Contour - Bone stock and MINT
beyondloadedSE is offline   Reply With Quote
Old 02-18-2008, 08:12 AM   #4
mre4ever
AF Newbie
Thread starter
 
Join Date: Feb 2008
Location: pontiac, Illinois
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
Re: 98 contour 2.5l dohc misfire/rough idle

Thanks guys, I will go ahead and try all that stuff tonight. I'll let you know how it works out. O and appriciate letting me know the whole timing chain thing. I am mechanically savvy, however, not good enough to do a complete rebuild. Thanks.
mre4ever is offline   Reply With Quote
Old 02-19-2008, 06:26 PM   #5
JoeShmoe
AF Enthusiast
 
JoeShmoe's Avatar
 
Join Date: Aug 2006
Location: DeLand, Florida
Posts: 1,579
Thanks: 0
Thanked 1 Time in 1 Post
Send a message via AIM to JoeShmoe
Re: 98 contour 2.5l dohc misfire/rough idle

Yeah bud, O2 sensor should do ti. If that fails then your MAF sensor. Allthough you didin't post a bad PCV in the codes.
__________________
'98 Contuor SE, 2.5 V6 Auto Silver
'08 Altima 2.5S, Auto Super Black
JoeShmoe is offline   Reply With Quote
Old 02-19-2008, 07:28 PM   #6
beyondloadedSE
AF Ford Contour-Advisor
 
beyondloadedSE's Avatar
 
Join Date: Mar 2003
Posts: 1,815
Thanks: 0
Thanked 2 Times in 2 Posts
Re: 98 contour 2.5l dohc misfire/rough idle

Quote:
Originally Posted by JoeShmoe
Yeah bud, O2 sensor should do ti. If that fails then your MAF sensor. Allthough you didin't post a bad PCV in the codes.
No way an 02 sensor would cause irratic idle.

I think most people think that if it throws a lean or rich code, that they think there O2 sensor is faulty, when in reality, its working perfectly and telling you exactly whats going on. If your O2 sensor is faulty, it will give a code like P0140: "Downstream Heated Oxygen Sensor circuit Faulty - Bank No. 1."

I would say, with an irratic idle, your more than likely running lean. Unmetered air is bypassing the MAF and causing your RPM's to shoot up. Could be IAC like I said. If your intake manifold gaskets are original, I would check those next. Those deteriorate pretty bad due to high engine temps and old age.

Btw, was it running lean or rich? It can't be both at the same time. Do you have the codes handy?
__________________

"The CEG Nazi"
www.contour.org
1996 Ford Contour SE - Sold
3.0L V6 and Arizona Dyno Chip Turbo Kit
364 whp, 410 wtq @ 16 psi and only 4,700 rpms.
1999 Tropic Green SVT Contour - Bone stock and MINT
beyondloadedSE is offline   Reply With Quote
Old 02-20-2008, 08:09 AM   #7
JoeShmoe
AF Enthusiast
 
JoeShmoe's Avatar
 
Join Date: Aug 2006
Location: DeLand, Florida
Posts: 1,579
Thanks: 0
Thanked 1 Time in 1 Post
Send a message via AIM to JoeShmoe
Re: 98 contour 2.5l dohc misfire/rough idle

Ditto, codes would really help. You're right, I was thinking about the downstream one. Does the IAC throw a code?


Basically, you are having a problem with air, thats all these units do.
__________________
'98 Contuor SE, 2.5 V6 Auto Silver
'08 Altima 2.5S, Auto Super Black
JoeShmoe is offline   Reply With Quote
Old 02-28-2008, 07:19 PM   #8
godfrey1680
AF Newbie
 
Join Date: Feb 2008
Location: Charlotte, North Carolina
Posts: 3
Thanks: 0
Thanked 0 Times in 0 Posts
Re: 98 contour 2.5l dohc misfire/rough idle

sounds like the throddle positioning sensor to me. I had that problem on my ford explorer.
godfrey1680 is offline   Reply With Quote
Old 02-29-2008, 02:14 AM   #9
jsweeter
AF Regular
 
Join Date: Jan 2005
Location: Hopkins, Michigan
Posts: 114
Thanks: 0
Thanked 0 Times in 0 Posts
Re: 98 contour 2.5l dohc misfire/rough idle

Sounds like what my car had about a year ago. I had a thread posted and it was the Idle Air Control valve (IAC) Try this before anything else. Does it make a humm noise at all?
jsweeter is offline   Reply With Quote
Old 05-04-2008, 10:39 AM   #10
pjw73nh
AF Regular
 
Join Date: Dec 2005
Location: Portsmouth, New Hampshire
Posts: 118
Thanks: 4
Thanked 0 Times in 0 Posts
Re: 98 contour 2.5l dohc misfire/rough idle

Quote:
Originally Posted by mre4ever
im new to this thread, however, i've pretty much read almost all of the contour threads on the problems these cars have. timing chain, vacuum leak, etc. Here's my problem/s.

I bought this car 2 1/2 weeks ago. ran good, no check engine light, nothing. then I started it up one day, and it ran the rpm's up to 2500 and back down to 300. If it doesn't die, then it goes back up and down several times until its warmed up. It still does it every day. Once it's warmed up it idles where it's supposed to, around 900 -1100 rpm somewhere in there, however it's still rough. I just replaced the plugs and wires, being that's the cheapest test. No change. Does the same thing. The only other problem, that I know of is that there's a small oil leak on the back valve cover. I check the oil everyday, and it isn't even 1/2 qt low in 2 1/2 weeks. Don't think that it's related to this problem. My guess is a coil pack??? or a maf sensor??? just looking for the best direction to go, without spending big $$$$ fixing this annoyance. Thanks in advance. O, I got the check engine light flashing, and the codes when read were, misfire on 1, and 3. car running to lean/rich, and o2 sensor upstream.

Had a similar issue a month ago. Turned out to be intake manifold gasket(s). Upper was leaking, but did the lower one while i was in there.
pjw73nh is offline   Reply With Quote
Old 05-04-2008, 05:22 PM   #11
beyondloadedSE
AF Ford Contour-Advisor
 
beyondloadedSE's Avatar
 
Join Date: Mar 2003
Posts: 1,815
Thanks: 0
Thanked 2 Times in 2 Posts
Re: 98 contour 2.5l dohc misfire/rough idle

Quote:
Originally Posted by pjw73nh
Had a similar issue a month ago. Turned out to be intake manifold gasket(s). Upper was leaking, but did the lower one while i was in there.
Like I said in my earlier post. Intake manifold gaskets.
__________________

"The CEG Nazi"
www.contour.org
1996 Ford Contour SE - Sold
3.0L V6 and Arizona Dyno Chip Turbo Kit
364 whp, 410 wtq @ 16 psi and only 4,700 rpms.
1999 Tropic Green SVT Contour - Bone stock and MINT
beyondloadedSE is offline   Reply With Quote
Old 02-12-2015, 07:36 PM   #12
FUKENEH
AF Newbie
 
Join Date: Feb 2015
Location: Calgary
Posts: 3
Thanks: 0
Thanked 0 Times in 0 Posts
Re: 98 contour 2.5l dohc misfire/rough idle

Had the same issue. First i replaced the upper intake manifold. This did not fix the problem.

The problem was the gaskets around the spark plugs on the valve covers. Got oil on the spark plugs and caused a misfire.
FUKENEH is offline   Reply With Quote
 
Reply

POST REPLY TO THIS THREAD

Go Back   Automotive Forums .com Car Chat > Ford > Contour

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 11:11 AM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts