Stalling and electrical components reset

[Prof_h]

Hi,
Recently I've noticed my car just stalls and all the electrical components reset. What gives? Anyone have this happen? I just replaced my fuel filter, thinking that needed changing, but the stalling happened again. It doesn't do it very often, but it sure is weird.
I also had the car SE light indicate that the Crank Shaft Position sensor was sending a code. The car runs fine, shifts a little rough into 4th sometimes, but everything seems okay, fluid levels are fine and I just had the tran. fluid changed. Any ideas?
97 PA 3.8 V6 140k miles

[C man]

Reset as in you have to reprogram the radio time etc.. or as in the car shuts of and comes back on?

[Jrs3800]

Originally Posted by Prof_h

Hi,
Recently I've noticed my car just stalls and all the electrical components reset. What gives? Anyone have this happen? I just replaced my fuel filter, thinking that needed changing, but the stalling happened again. It doesn't do it very often, but it sure is weird.
I also had the car SE light indicate that the Crank Shaft Position sensor was sending a code. The car runs fine, shifts a little rough into 4th sometimes, but everything seems okay, fluid levels are fine and I just had the tran. fluid changed. Any ideas?
97 PA 3.8 V6 140k miles

Sounds a lot like a ground issue with the electrical system.. Check all of the grounds you can find, start under the hood...