View Single Post
Old 12-04-2018, 07:36 PM   #1
lothian
AF Newbie
 
Join Date: Jun 2016
Location: raleigh, North Carolina
Posts: 21
Thanks: 0
Thanked 2 Times in 2 Posts
T'shooting Transmission Solenoid Assembly

I’m working through the A/T Clutch Pressure Control Solenoid Valve A/B Assembly test procedure listing in the Honda Service Manual (HSM), followed by the Lock-up Control Solenoid Valve - Shift Control Solenoid Valve A Assembly test. My question concerns resistance readings on one of the assemblies.

HSM lists normal resistance for both assemblies. The resistance on the lock-up control solenoid valve is well within the acceptable range. However, resistance of the a/t clutch pressure control solenoid valve a/b is ~6Ω on both solenoids—HSM says it should be 5Ω.

I interpret ~6Ω resistance across both solenoids in the a/t clutch pressure control solenoid valve a/b assembly as high, and I was about to order a replacement. But it’s only ~1Ω over spec and I’d hate to order a part that doesn’t require replacement.

Thought? Opinions?
lothian is offline   Reply With Quote