Sorry it's been a while but I've been way too busy. Ok, so I've looked further into my issue. It seems that part of my air intake tube was melted (about a qaurter a fingers width) and my engine was getting some straight air into it (non filtered). I could only imagine what that was doing to my engine and my air sensor's. So I went to the junk yard and picked up a air intake tube. My issue now is that the sensor seems as if it wont come out. Do I need a special tool so I can change out the air sensor to put in the new (used) air intake tube? By the way..... YES I diagnosed the problem TECHII, hence why I am asking these questions.
F.Y.I - All is good with the engine (as far I know) it seemed as if the previous owner did something stupid to have that part melt. The air filter is clean (K&N air intake). I cleaned it myself.