View Single Post
Old 05-26-2017, 07:44 PM   #3
Tech II
AF Fanatic
 
Join Date: Jul 2011
Location: Worcester, Massachusetts
Posts: 5,017
Thanks: 70
Thanked 618 Times in 610 Posts
Re: '97 Olds Achieva Passlock Issues

Well first, I don't believe the '97 Achieva uses a BCM, it uses the IPC......

In the past, I have repaired these systems 3 ways.....

Replace the PassLock sensor.....

Install a resistor......

Install a toggle switch......the easiest approach......you cut the yellow wire to the lock cylinder and install a toggle switch(place the switch in an easily accessible spot......close switch......do relearn procedure....car starts and the THEFT LIGHT GOES OUT......NOW OPEN THE TOGGLE SWITCH, with the engine still running.....the THEFT light will come back on, but the engine will continue to run........now shut the vehicle off.......restart car......it will start and run, but the THEFT LIGHT WILL REMAIN ON......that is the price of installing a toggle switch.......this is like a backup mode.......if you have the wrong resistance at startup, the car will not start......but if the car starts, and runs, and then loses the resistance reading, it goes into a back up mode, and will continues to restart, with a Security codes set.....however, if the code is cleared, OR, if the battery dies or is disconnected, this resets the code and it is no longer in backup mode...now if you try to start the vehicle, and the R code is wrong it will not start.......so, let's say, for some reason, you have to disconnect the battery, chances are it will not restart......so you close the toggle switch, do the relearn procedure, the car will then start, the Theft light will go out....with CAR STILL RUNNING, you open the toggle switch....car continues to run, Theft light comes back on, but the car will restart, because you are in backup mode again....
Tech II is offline   Reply With Quote
The Following User Says Thank You to Tech II For This Useful Post:
81eagle (05-31-2017)