View Single Post
Old 03-26-2015, 07:49 PM   #1
element771
AF Newbie
 
Join Date: Mar 2015
Location: Birmingham, Alabama
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
bent valve?!? 2004 jetta

I was wondering if I could get some advice or suggestions. I would greatly appreciate it.

I have a 2004 Volkswagen Jetta. My wife was driving it in the parking lot when she heard a pop and immediately pulled into a space. Engine coolant (antifreeze) was pouring out from under the hood. I tried adding more but it just flowed right through.
Brought it to a shop and they found that my water pump had seized resulting in a “shredded” time belt with only about 10 teeth left. They replaced the belt, the water pump, and water housing for about 800 bucks. They test drove it and it appeared to be fine. The mechanic said that I got really lucky.
I brought it home and it ran really well, actually better than when I brought it in. A couple of days went by and the check engine light went on. I pulled the code (p0303) which means a detected misfire in cylinder 3. I reset the code as I thought that it may have just been a remnant of the initial event. Five days go by and the light comes back on. I always comes on when I first start the car before I even put it in drive. I have listened to the engine and it doesn’t sound like that there is anything wrong.

I was curious to see if this could be the result of a bent valve from a week ago or more likely an unrelated issue.

Thanks for any information or advice that you could provide!!
element771 is offline   Reply With Quote