[Frah2o]

I finished the job with front and rear axle. To fit properly the new rims i machined a rc 1/10 hub adapter from 4,5 to 6 mm. With this new size now the rc center adapter fit on hub (disc are only dry fitted for have right size and clearence)
In the nexts post i’ll write a “flashback post” to show the previous work do on absorber fully reworked and converted in airride system.
The extra engine mount bracket works properly with right wheel shaft. Also the shafts can work good with chassis notching
I fitted the stabilizer bar and finally i painted the chassis rubber grommets
I fitted the bodyshell to check if all is good and for have test with new N group tailpipe.