I just received a loaner 84 cr250 for me to ride. It was not running for reasons of a bad head gasket... which I found out was just the start of the problems. The head gasket leaked so badly that all of the coolant was either in the exhaust, the cylinder, or the crankcase. I repeat... ALL of it
Fun project anyway.
The bores look good, as does the piston and rings, but the bottom end has been soaking in water for a few months now. Should I just dry it out, bathe it in oil for a while and run it anyway? Or should I pull it out and rebuild?
The gearbox has a slight crack right around the drain plug. Should I have my buddy TIG weld it while its out, or will that harm the case worse than it is?
Is there an online PDF manual for this bike that anyone knows of?
Thanks