Quote:
Originally Posted by TallyMatt
OK, Thanks for responding, but its still not clear to me:
1.) Yes or No, should I dump out the factory pre-filled oil that comes in my new compressor? If yes, am I dumping it out to discard it completely, or only to measure it and put it right back into the new compressor? Or am I removing it for some other reason?
2.) You say to fill from the suction side...OK.... Does this mean I put NO OIL in the compressor and put ALL 8oz in the suction side? Do I put the oil in before vacuuming? I've got the liquid type oil in the bulk can with the metal screw-off lid..... so, I just unscrew & pour. Its not the pressurized container of oil (recharge kit).... Should I be using the compressed oil instead of the bulk pour can?
|
what mt2500 stated I agree with...after the oil is installed start vacuum on system until its low and stable...hold vac..then start charging..do not put too much in keep low side pressures below 50 psi...
I keep at 40 - 45psi ...
use the ac gauge set valves to switch from vac pump to charging cylinder..