Quote:
Originally Posted by CrateCruncher
The next BMF covered the top surface and rounded the blade to meet and just overlap the bottom BMF. After burnishing that down I used some worn 3600 emery cloth to carefully sand just the edge at the overlap so it wasn't noticeable.
|
Overlapping and burnishing BMF "splices" sounds like an art form in itself. Any chance of an illustrated tutorial?
I do appreciate yours - and everyone's - encouragement. Because of the cost and the delay, I'm not quite ready to send parts to a chrome shop, but I definitely want to try the new Spaz Stix formula that Bob mentioned.
Thanks to all.
Tom