View Single Post
Old 01-07-2012, 09:13 AM   #1
evotastic.ca
AF Newbie
 
evotastic.ca's Avatar
 
Join Date: Jan 2012
Location: Ottawa, ON
Posts: 14
Thanks: 0
Thanked 0 Times in 0 Posts
Smile evotastic.ca 600whp Drag Evo

Hi all, this project was started more than a year ago. I will be posting up some content to get up to date on where I'm currently standing, slowly .

I am trying to build a 600whp, Evo 1. The early evos run the same engines as dsm's (mostly), and I found it may be fitting to have it here. If you're interested in following me further, you can follow me on twitter @eevotastic

Thanks!

Exhaust & Back

The overly technical setup was built not to bottleneck the turbo. If a 59mm compressor gets maxed out on the .55 A/R DSM housing, it might be a wise idea to go for a bigger exhaust housing if the compressor size is increased by 3mm. Also, a 62mm turbo will have considerably slower spool than your average 16G. Add to that the size of the T3 setup, and you’ll be lucky to spool before midnight. In comes the divided T3, equal length, ceramic coated tubular manifold. It includes two 44mm gate ports, to hopefully gain some spooling RPM. Read more

Stay tuned
__________________
Follow my 600whp Drag Evo Build at
http://evotastic.ca
& follow me on twitter at
@eevotastic
evotastic.ca is offline   Reply With Quote