sharker :
96 Concorde, Intrepid, LHS, New Yorker, Vision programming
1) Turn ignition ON
2) Connect a jumper wire from pin 1 of the DLC (Data link Connector located at bottom edge drivers side under dash) Pin 1 is the upper left pin. Take other end of jumper wire to ground. The door locks will LOCK then UNLOCK to verify system is in program mode
3)Press any transmitter button. Doors will LOCK then UNLOCK to verify.
4) Repeat step 3 for any additional transmitters.
5) Remove jumper wire. Turn ignition OFF.
6) Verify transmitter functions.