Update:
Suspension units completed and painted according to the references...
The rear sub frame and upright support need a little work and will benefit from some re-work... I removed the support bars that attach to the body as these will be replaced with metal rod and detailed either end with fastening nuts...
The brake discs are relatively plain looking affairs (vented discs in F1 were a little way off in 1965) and so these only need painting in the appropriate colours. I detailed them with some hose joints from Hobby Design which will be connected with brake lines later.
I added the oil tank tot he rear of the engine frame, this was detailed with a strap to hold it down which will have an etched buckle which attaches to the exhaust bracket on the real car.
Lower exhausts installed...
Finally for this update, suspension units, uprights and remaining sub frame - detailed with bolt heads. The top exhausts added too but only as a dry fit, I also installed a scratch made throttle linkage including spring which completed the injection assembly.
