View Single Post
Old 09-23-2011, 06:28 PM   #3
dksob81
AF Enthusiast
Thread starter
 
Join Date: Aug 2004
Location: Sharon, Pennsylvania
Posts: 2,746
Thanks: 0
Thanked 1 Time in 1 Post
Send a message via ICQ to dksob81 Send a message via AIM to dksob81 Send a message via MSN to dksob81 Send a message via Yahoo to dksob81
Re: 86 Mark VII LSC Engine rebuild now the engine wont start

Ok, I just seen a small (5/16" head) bolt on the driverside inner fender, behind the battery. I think there was a ground wire that went here, but I cannot find any wires hanging.
Does anyone have any clue as to where the wires go from this bolt?
__________________
R.I.P. - 94 Jeep Grand Cherokee Limited 5.2L V8 Quadra-Trac, 3" Budget Boost, K&N FIPK Gen II (Cold Air Intake), FlowMaster American Thunder (Exhaust).

W.T.T.F. - 1998 Jeep Grand Cherokee 5.9 Limited - Deep Slate Pearl - K&N FIPK GEN II (COLD AIR INTAKE), Altezza Tails and Crystal Clear Front end light with HID Kit and NP242 Swap.

dksob81 is offline   Reply With Quote