View Single Post
Old 11-27-2006, 09:24 PM   #10
tczer34
AF Newbie
 
Join Date: Nov 2006
Location: Endwell, New York
Posts: 6
Thanks: 0
Thanked 0 Times in 0 Posts
Re: Replacing intake gasket...

Bear with me as I talk through your directions....If i am looking at the fuel rail as it is attached to the lower intake manifold I see 2 main sections, imagine x axis front and back. They are connected permanately by a section on the left hand side, y axis. On the right hand side there is a return line, fuel pressure regulator (connected to front rail) and in back the feed line with an odd bolt that screws into the fuel rail. If I loosen that bolt isn't there a way to remove that feed line?

If I picture the way you describe i follow that Feed line down along the block but eventually I hit a plastic sleeved section.

Apparently I am lost.
tczer34 is offline   Reply With Quote